Results 201 to 210 of about 4,511,405 (380)

3D‐Printed Architected Material for the Generation of Foam‐Based Protective Equipment

open access: yesAdvanced Engineering Materials, EarlyView.
This study investigates 3D‐printed architected structures as alternatives to traditional foams in protective gear. It focuses on customizing impact strength and damping through design and manufacturing integration. Testing shows these structures outperform conventional foams, offering enhanced customizability, lower weight, and tunable performance ...
Ali Zolfagharian   +5 more
wiley   +1 more source

Influence of Temperature on Scratch and Wear Properties of Technical Thermoplastics: Implications for Material Selection

open access: yesAdvanced Engineering Materials, EarlyView.
The share of technical thermoplastics is expected to grow further in the e‐mobility segment. In this study, a detailed temperature‐based tribological characterization of technical thermoplastics is performed. The tribological properties are discussed in terms of the dynamic mechanical properties of polymers at different ambient temperatures. A proof of
Harsha Raghuram   +2 more
wiley   +1 more source

Design and development of a motion compensator for the RSRA main rotor control [PDF]

open access: yes
The RSRA, an experimental helicopter, is equipped with an active isolation system that allows the transmission to move relative to the fuselage. The purpose of the motion compensator is to prevent these motions from introducing unwanted signals to the ...
Huber, R., Jeffrey, P.
core   +1 more source

Tribology of ZrC Coatings and Spherical Tips Acquired with Extraordinarily Stiff, Metal Atomic Force Microscopy Probes

open access: yesAdvanced Engineering Materials, EarlyView.
In this research, ZrC coatings are evaluated against various counterprobes at the microscale using novel super‐stiff atomic force microscopy cantilevers. The chemical composition of the coating is shown to be an important factor influencing coating hardness and Young's modulus, while surface roughness, counterprobe hardness, and surface energy are the ...
Piotr Jenczyk   +4 more
wiley   +1 more source

Fabrication of a Stable, Low‐Cost, Patient‐Specific, Brain Phantom with Ventricles for Ultrasound Imaging

open access: yesAdvanced Engineering Materials, EarlyView.
Patient‐specific brain phantoms can replace animal trials, aid presurgical training, and enable in silico disease research on cerebrospinal fluid and ventricles. This study presents a method to create ventricular brain phantoms from three‐dimensional magnetic resonance images brain scans, resulting in durable, tunable, reproducible models that mimic ...
Kajal Chandraprakash Jain   +3 more
wiley   +1 more source

Home - About - Disclaimer - Privacy