Results 121 to 130 of about 6,550,271 (297)
Advanced Engineering Materials, EarlyView.Despite benefits to storage stability and handleability of aluminum scrap, octadecyl phosphonic acid (ODPA) SAMs reduce the tensile strength of wires produced using friction‐induced recycling. Etching and methyl diphosphonic acid (MDPA) coatings, however, have little effect.
Timothy D. Goller +3 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.A high interstital austenitic steel is additively manufactured and postdensified by HIP to eliminate gas porosity. Thereby, the loss of N and Mn in Ar HIP atmosphere is investigated. Further, HIP using N2 atmosphere is investigated which led to excessive nitride formation.
F. Großwendt +4 more
wiley +1 more source
Electrodeposition in Structural Lattices of Variable Architectures
Advanced Engineering Materials, EarlyView.Electrodeposition enables geometry‐sensitive, autonomous void filling while simultaneously tuning chemical and mechanical properties. The development of approaches that can autonomously fill and heal material voids and yield composites with tailorable properties is increasingly relevant in engineering.
Yeong‐Man Kwon +3 more
wiley +1 more source
Ground compaction due to vibrodriving of piles [PDF]
, 1996 Civil engineering construction frequently requires the use of piles to carry structural loads to stronger ground strata or to control lateral ground movements. A variety of techniques are available to install piles into the ground. Of central interest to
Bement, R.A.P., Bement, R
core
Study on Ground Deformation During Shield Tunnel Construction
, 2021 Through the systematic analysis of the ground settlement generatedby the process of shield tunneling, the relationships between grounddeformation and construction parameters are studied in this paper. Basedon the assumption of linear small deformation, a
Zhang, Zhongkun
core
Advanced Engineering Materials, EarlyView.Additively manufactured AlCrFe2Ni2 with contrasting BCC/B2‐dominant and lamellar FCC + BCC/B2 microstructures exhibits the same pressure‐induced BCC/B2 → HCP transformation. Under laser heating at high pressure, HCP is destabilized, and a cubic BCC/B2 + FCC assemblage is recovered, while the lower‐scan‐speed microstructure transforms at a lower ...
Raimundas Sereika +5 more
wiley +1 more source
Spatiotemporal Prediction of Ground Surface Deformation Using TPE-Optimized Deep Learning
Remote SensingSurface deformation induced by the extraction of natural resources constitutes a non-stationary spatiotemporal process. Modeling surface deformation time series obtained through Interferometric Synthetic Aperture Radar (InSAR) technology using deep ...
Maoqi Liu +4 more
doaj +1 more source
Characters of Surface Deformation and Surface Wave in Thermal Capillary Convection
, 2006 In the field of fluid mechanics, free surface phenomena is one of the most important physical processes. In the present research work, the surface deformation and surface wave caused by temperature difference of sidewalls in a rectangular cavity have ...
Duan, L (reprint author), Chinese Acad Sci, Inst Mech, Natl Micrograv Lab, Beijing 100080, Peoples R China. +3 more
core +1 more source
Impact of Hydrogen Incorporation on Electronic and Magnetic Structure of X2CrNi18‐9 Stainless Steel
Advanced Engineering Materials, EarlyView.Hydrogen uptake in austenitic stainless steel alters both its electronic and magnetic structure. Seebeck measurements reveal hydrogen‐induced shifts in the electronic density of states, while neutron scattering uncovers nanoscale inhomogeneities that grow upon hydrogen incorporation, with the most pronounced effect observed in the PBF as‐built state ...
Torben Tappe +9 more
wiley +1 more source
Net Gains from Conjunctive Use of Surface and Ground Water [PDF]
Pakistan is fortunate enough because its soils, topography and climate are generally suitable for farming but its agriculture sector faces the problem of scarcity of the irrigation water.
Waqar A. Jehangir +2 more
core