Results 1 to 10 of about 1,300 (117)

Ground tire rubber filled low-density polyethylene: The effect of particle size

open access: yesAdvanced Industrial and Engineering Polymer Research, 2022
In the present study, we investigated the possibility of value-added recycling of ultrafine ground tire rubber (uGTR) produced from water jet milling, with an average particle size of a few tens of microns.
Lóránt Kiss   +5 more
doaj   +3 more sources

Enhanced surface activation of ground tire rubber via the radiolysis of water for effective rubber recycling [PDF]

open access: yesHeliyon
In this study, we examined the chemical changes occurring in ground tire rubber (GTR) and on its surface as a result of gamma irradiation in water, with low doses of 5, 10, 15, 20, 25, and 30 kGy. To better distinguish the changes the radiation caused in
Lóránt Kiss   +6 more
doaj   +2 more sources

Production of Lightweight Three-Layered Particleboards Using Waste Tire Rubbers

open access: yesDrvna Industrija, 2023
The aim of the study is to investigate the production possibilities of particleboard by using waste tirerubbers with different properties as fillers and find a solution to a serious environmental pollution problem caused by waste tires. For this purpose,
Cem Köse   +3 more
doaj   +2 more sources

Structure and properties of high-content rubberized asphalt

open access: yesHecheng xiangjiao gongye, 2022
The content of ground tire rubber was limited by its multiple cross-linking networks. High-content ground tire rubber modified asphalt (mass fraction of ground tire rubber more than 30%) binder could be produced by addition of degraded tire rubbers (DR),
YU Xiao-xiao, YANG Wei, LU Yong-chun, LI Xiao-tun, WANG Shi-feng
doaj   +1 more source

Producing Interpenetrating Network from Waste Tires Rubber with commercial Unsaturated Polyester [PDF]

open access: yesمجلة التربية والعلم, 2022
Waste tires constitute environmental problems because of their three-dimensional complicated structure. The presence of different additives within their composition makes them difficult to degrade.
Rasha AL Jarah, Asaad Khattab
doaj   +1 more source

Sustainable development of waste tires recycling technologies – recent advances, challenges and future trends

open access: yesAdvanced Industrial and Engineering Polymer Research, 2021
Dynamic development of the automotive industry and the growing number of various vehicles generate demand for the global production of tires. Simultaneously, high performance of tires cause serious problems with further management and recycling of end-of-
Krzysztof Formela
doaj   +1 more source

An improved LuGre model for calculating static steering torque of rubber tracked chassis

open access: yesDefence Technology, 2022
Tire and rubber track interchangeable chassis combines the advantages of tire and rubber track, which can greatly improve the maneuverability of military construction machinery.
Kang Liang   +6 more
doaj   +1 more source

Waste tire rubber-based materials: Processing, performance properties and development strategies

open access: yesAdvanced Industrial and Engineering Polymer Research, 2022
In the many countries the main strategy for waste tires utilization is still energy recovery, which use waste tires as low-cost and high-calorific alternative fuel.
Krzysztof Formela
doaj   +1 more source

Investigation of the mechanical, tribological and corrosive properties of epoxy composite coatings reinforced with recycled waste tire products

open access: yeseXPRESS Polymer Letters, 2022
The present work aims at evaluating the mechanical and anti-corrosion behaviour of epoxy coatings modified by recycled waste tire products. In this study, the epoxy coatings reinforced with ground tire rubber (GTR), devulcanised ground tire rubber (DGTR),
Fazliye Karabork
doaj   +1 more source

Effect of ultrasonic amplitude on ultrasonic desulfurization process and performance of ground tire rubber

open access: yesHecheng xiangjiao gongye, 2022
The desulfurized ground tire rubber (DGTR) was prepared from 40 mesh waste ground tire rubber by ultrasonic desulfurization process in an ultrasonic co-rotating twin- screw extruder.
ZHANG Xiao-ping; Isayevich Avraam ISAYEV; CONG Hou-luo; WANG Yan-qiu; ZHANG Yan-ge
doaj   +1 more source

Home - About - Disclaimer - Privacy