Results 231 to 240 of about 2,571,636 (343)

Mechanical Behavior and Microstructural Changes Associated with Tensile Deformation above the Martensite Start Temperature during Quenching and Subsequent Partitioning of a Low‐Alloy 37SiB6 Steel

open access: yesAdvanced Engineering Materials, EarlyView.
A new experimental setup, incorporating digital image correlation and infrared thermography in combination with inductive‐conductive heating for precise temperature control, is used to analyze the mechanical behavior and microstructural changes of sheet metal under complex thermomechanical test conditions that represent quench and partitioning ...
Christian Illgen   +4 more
wiley   +1 more source

Development of Aluminum Scandium Alloys for Hydrogen Storage Valves

open access: yesAdvanced Engineering Materials, EarlyView.
Different aluminum alloy series and various aluminum‐scandium alloys with differing Sc and Zr levels are evaluated for use in hydrogen storage valve production. The alloys undergo hardness testing, optical microscopy, and tensile strength analysis, with hardening behavior studied under varying conditions.
Francisco García‐Moreno   +4 more
wiley   +1 more source

Vacuum‐Formed Composites Based on a Polyolefin and a High Content of Biomass‐Waste Fillers

open access: yesAdvanced Engineering Materials, EarlyView.
It is shown here that by the use of a very ductile polymer matrix, it is possible to vacuum‐form products that contain up to 25% of hard biofillers with still ductile properties. The results are promising and opens up for the use of engineered biocomposites derived from industrial side‐stream biofillers in vacuum‐formed products. A strategy to increase
Susanna K. Källbom   +6 more
wiley   +1 more source

Combining Metal Additive Manufacturing and Casting Technology: High Performance Cooling Channels for Electric Powertrain Components

open access: yesAdvanced Engineering Materials, EarlyView.
When realized as inserts in high‐pressure die casting, aluminum cooling channels for electric powertrain components and similar applications typically require a stabilizing filler to survive the process. The present study investigates relinquishing this filler using additively manufactured inserts promising performance improvements.
Dirk Lehmhus   +9 more
wiley   +1 more source

Home - About - Disclaimer - Privacy