Results 121 to 130 of about 4,782,069 (378)
Evaluation of Grounding Impedance of a Complex Lightning Protective System Using Earth Ground Clamp Measurements and ATP Modeling [PDF]
A new Lightning Protection System (LPS) was designed and built at Launch Complex 39B (LC39B), at the Kennedy Space Center (KSC), Florida, which consists of a catenary wire system (at a height of about 181 meters above ground level) supported by three ...
Mata, Angel G. +2 more
core +1 more source
Tendencies in the design of the grounding devices for the electrical installations of the belarusian energy system [PDF]
, 2020 Mikhail Drako, S. M. Baraishuk
openalex +1 more source
Advanced Functional Materials, EarlyView.For the first time, a highly sensitive electrochemical biosensor based on SiO2‐based hairy particles with a grafted PDMAEMA polymer brush containing a quantifiable and large amount of immobilized Laccase is reported. The fabricated biosensor exhibits a sensitivity of 0.14 A·m⁻¹, a limit of detection (LOD) of 0.1 µm, and a detection range of 0.3–750 µm,
Pavel Milkin +7 more
wiley +1 more source
Electrical engineering & Electromechanics, 2014 Results of research on distribution of electric potentials on the earth surface in the territory with a grounding conductor are analyzed. It is shown that potential over the center of a square grounding conductor can be higher than that over the ...
I.V. Nizhevskyi +2 more
doaj
Application of a DC Distribution System in Korea: A Case Study of the LVDC Project
Applied Sciences, 2019 With the rapid expansion of renewable energy and digital devices, there is a need for direct current (DC) distribution technology that can increase energy efficiency.
Juyong Kim +4 more
doaj +1 more source
Latched Detection of Excited States in an Isolated Double Quantum Dot
, 2004 Pulsed electrostatic gating combined with capacitive charge sensing is used to perform excited state spectroscopy of an electrically isolated double-quantum-dot system.
A. C. Gossard +6 more
core +1 more source
DESIGN OF GROUNDING GRID CONDUCTOR POSITIONING DEVICE ON THE MAGNETIC FIELD METHOD
, 2018 The location and topology of grounding grid conductors are necessary to corrosion diagnosis and digging in most cases. In this paper, an integrated detecting device for grounding conductor buried position is designed.
Xiaokuo Kou +6 more
semanticscholar +1 more source
Advanced Functional Materials, EarlyView.The dielectric properties of clays are studied on the level of individual monolayers and functional double stacks. The material breakdown characteristics and charge storage performance are analyzed. For illustration, a defined charge pattern representing a cuneiform character is produced, written into a microscopic clay tile, referencing the origins of
Sebastian Gödrich +6 more
wiley +1 more source
Evaluation of the Overheight Detection System Effectiveness at Eklutna Bridge [PDF]
, 2013 The Eklutna River/Glenn Highway bridge has sustained repeated impacts from overheight trucks. In 2006, ADOT&PF installed an overheight vehicle warning system. The system includes laser detectors, alarms, and message boards.
Lee, Ming, Moose, Dan
core
Fast‐Responding O2 Gas Sensor Based on Luminescent Europium Metal‐Organic Frameworks (MOF‐76)
Advanced Functional Materials, EarlyView.Luminescent MOF‐76 materials based on Eu(III) and mixed Eu(III)/Y(III) show rapid and reversible changes in emission intensity in response to O2 with very short response times. The effect is based on triplet quenching of the linker ligands that act as photosensitizers. Average emission lifetimes of a few milliseconds turn out to be mostly unaffected by
Zhenyu Zhao +5 more
wiley +1 more source