Results 51 to 60 of about 5,253 (287)

Near‐Field Electrospinning Micro‐Printhead Achieves Precise Control of Nanofiber Deposition

open access: yesAdvanced Engineering Materials, EarlyView.
A micro‐printhead for near‐field electrospinning enables reproducible deposition of polymer nanofibers with diameters below 50 nm. Systematic parameter studies uncover the mechanisms linking operating conditions to fiber morphology, paving the way for precise and low‐cost nanoscale 3D manufacturing.As a high‐resolution, cost‐effective, and rapid ...
Han Xu, Dario Mager, Jan G. Korvink
wiley   +1 more source

Analysis Grounding System as Building Equipment Security Udayana University Denpasar

open access: yesJournal of Electrical, Electronics and Informatics, 2017
Grounding system is one of the components in building equipment security. To fulfill the operational continuity of electronic equipment in Faculty of Engineering, Udayana University, Denpasar, a grounding system with a ground resistance of ?
I G. N. Janardana   +3 more
doaj   +1 more source

Grounding Resistance and Grounding Impedance of Horizontal Bundled Conductor Grounding Electrodes.

open access: yesIEEJ Transactions on Power and Energy, 2003
It is well known that increasing conductor radius of grounding electrode results in decreasing grounding resistance, but the decrease extent is very little compared with the increase extent. However, when bundled conductors are used for grounding electrode, lower grounding resistance is expected to be obtained. Thus the bundled conductors of horizontal
Takashima, Takeshi   +2 more
openaire   +2 more sources

Hydrogen‐Assisted Fracture of Iron‐Based Fe–Ni–Al Alloys

open access: yesAdvanced Engineering Materials, EarlyView.
Principal relations and fracture mechanisms of single‐phase and precipitate‐strengthened Fe–Ni–Al alloys subjected to prior electrochemical hydrogen charging are identified. The mechanisms of hydrogen effect on strength and microhardness are discussed, including hydrogen‐induced increase in microhardness and the role of hydrogen in fracture behavior ...
Nataliya Yadzhak   +3 more
wiley   +1 more source

Electrochemical Behavior of Flame‐Sprayed Sc‐Doped AlCoCrFeMo High‐Entropy Alloy Coatings in 3.5% Sodium Chloride Solution

open access: yesAdvanced Engineering Materials, EarlyView.
Scandium (Sc)‐doped AlCoCrFeMo HEA coatings are fabricated via flame spraying with 0.1, 0.3, and 0.5 wt% Sc additions. Among these, the HEA‐Sc0.3 coating exhibits the highest corrosion resistance, indicated by a more positive corrosion potential and lower current density.
Pankaj Kumar   +7 more
wiley   +1 more source

Influence of Surface Finish on the Tribological Performance of AlTiBN Coatings Deposited on Forming Tools

open access: yesAdvanced Engineering Materials, EarlyView.
Aluminum and nitride coatings are used in industry because they are hard, resist wear, and protect against oxidation. Adding boron can improve friction behavior and other properties. This study tests coatings on surfaces with different finishes. Results show smoother surfaces perform better, while rough ones wear faster, although coatings can reduce ...
Adrián Claver   +9 more
wiley   +1 more source

Investigasi Kinerja Resistansi Pentahanan (Grounding) pada Lahan Rawa Timbun [PDF]

open access: yes, 2021
: This study aimed to determine the grounding resistance (grounding) in swampland. The method used in this research is to use the driven rod method. The investigation results through measurements with the 3 point method as well as with variations in
Yani, Raden Ahmad, Putra, Dian Eka
core   +2 more sources

A new grounding model for complex soil environments [PDF]

open access: yesE3S Web of Conferences, 2019
The purpose of arranging the grounding electrode is to discharge large currents, such as fault current and ensure the transmission line operate safely.
Pan Chong   +5 more
doaj   +1 more source

Microstructure Reconstruction in Battery Electrodes Using Machine Learning Based on Low‐Voltage Focused Ion Beam–Scanning Electron Microscopy Tomography Images

open access: yesAdvanced Engineering Materials, EarlyView.
Low‐voltage FIB‐SEM tomography combined with a image preprocessing pipeline improves phase contrast and enables reliable machine‐learning segmentation of conductive networks in lithium‐ion battery electrodes. Structural descriptors are extracted from segmented images, done semimanually and automated, and compared.
Lisa Beran   +6 more
wiley   +1 more source

The Impulsive Coefficient Of Short Grounding Electrodes [PDF]

open access: yes, 2007
This paper presents some preliminary experimental results developed by the authors regarding the response of grounding electrodes to impulsive currents.
Visacro, Silverio
core  

Home - About - Disclaimer - Privacy