Results 101 to 110 of about 5,253 (287)
A TECHNIQUE OF MEASURING OF RESISTANCE OF A GROUNDING DEVICE
Introduction. Measurement of resistance of the grounding device (GD) by means of a three-electrode system. This requires not only the right choice of installation locations of measuring electrodes, but also the determination of the point of zero ...
I.V. Nizhevskyi, V.I. Nizhevskyi
doaj +1 more source
Controlled large-scale tests of practical grounding electrodes--part II: comparison of analytical and numerical predictions with experimental results [PDF]
This paper presents tests carried out at an outdoor experimental facility, described in the companion Part 1 paper, to investigate the performance of practical grounding systems. Here, the results of low-voltage dc, ac, and impulse tests performed on rod
Harid, N. +6 more
core +1 more source
A piezoelectric microacoustic wave device exploiting topologically protected interface states with significantly higher dynamic compliance than Lamb or Rayleigh modes achieves record‐high out‐of‐plane particle velocities exceeding 51 m/s. These findings indicate that leveraging topological interface states can overcome key limitations of piezoelectric ...
Onurcan Kaya +12 more
wiley +1 more source
The continuous current dissipation of direct current grounding electrodes generates intense Joule heat, causing severe soil moisture loss and localized thermal runaway. Traditional static models ignore the temperature-dependent nature of soil parameters,
Changzheng Deng, Zechuan Fan, Weiyi Li
doaj +1 more source
Ferroelectric nanoclusters create local internal fields in a normally non‐switchable polar film because of polarization mismatch at their interfaces. That field opposes polarization in the regions with larger polarization and reinforces polarization in the regions with smaller polarization.
Anna N. Morozovska +5 more
wiley +1 more source
Parallel processing applied to the design of concrete encased grounding electrodes [PDF]
This work presents the authors investigation regarding the application of parallel processing to the design of grounding systems, comprising concrete encased electrodes.
Silveira, Humberto de Aquino +3 more
core +2 more sources
A non‐aqueous, solution‐based graphene‐wrapping strategy is shown to stabilize disordered rocksalt LMTOF cathodes without structural degradation. The graphene‐wrapped cathode suppresses oxygen loss and parasitic interfacial reactions, lowers impedance growth, and delivers improved cycling stability and rate capability compared with conventional ball ...
Venkata Sai Avvaru +14 more
wiley +1 more source
Effect of Optical Illumination on Bubble Nanodomains
Stable surface‐confined nanoscale bubble domains are created and manipulated in PMN‐PT single crystals. Under above‐bandgap illumination, these bubble nanodomains remain unchanged. However, upon illumination cessation, they rapidly expand to switch the entire crystal surface, due to the accumulation of a large reservoir of electrons at the crystal ...
Haoze Zhang +8 more
wiley +1 more source
Analysis of the Influence of Complex Terrain around DC Transmission Grounding Electrodes on Step Voltage [PDF]
The distribution of renewable energy sources is geographically limited. In the process of long-distance transmission, the direct current flowing from a ground electrode into the ground will cause a higher step voltage, which will bring serious security ...
Shuang Qiu +4 more
core +1 more source
Design of Grounding Grid for Main Substations in High Soil Resistivity Areas Based on CDEGS Software
Objective To address the difficulty of reducing the grounding resistance of main substations in high soil resistivity areas, it is necessary to study the design of grounding grids for main substations in such regions.
CAO Jianshe
doaj +1 more source

