Results 51 to 60 of about 1,603,019 (133)

Turbulence‐Intensity Effects on the Aerodynamic Performance of an H‐Type Darrieus Wind Turbine: A URANS Parametric Study

Energy Science &Engineering, EarlyView.
Turbulence intensity from 1% to 25% was parametrically tested on a three‐bladed H‐type Darrieus rotor across five tip speed ratios (TSRs) using two‐dimensional URANS. The optimal TSR proved the most efficient and most robust operating point simultaneously, with Cp losses capped at 5.8% even at TI = 25%. ABSTRACT The effect of inlet turbulence intensity
Aydin Ulus
wiley   +1 more source

Performance Research on the Axial Flow Fan Adding Guide Vane

, 2011
Fan is a major part of the cooling system in the vehicle, axial flow fan is used very common recently. In order to improve the cooling capability, cooling fan’s structure has been changed; experiment research and numerical simulation are done for it. The
Hong Fei Zheng, Wang Rui, Yi Chun Wang, Chao Qing Feng   +3 more
core   +1 more source

Study of the Internal Cyclonic Flow Characteristics of Cyclones with Different Guide Vane Heights

, 2022
To investigate the influence of the guide vane height on the cyclonic flow characteristics of guide vane cyclones, this paper mainly adopts a combination of numerical simulation and physical experiments, taking the guide vane height as the research ...
Xiaoteng Song, Yongye Li, Siyuan Tao, Jiaxuan Zhang   +3 more
core   +1 more source

Spacing Effects in Guided Vertical‐Axis Wind Turbine Arrays for Highway Energy Harvesting Under Multi‐Vehicle Wake Conditions

Energy Science &Engineering, EarlyView.
Three‐turbine guided Savonius arrays installed along highway corridors extract up to 697 J under multi‐vehicle wake conditions when spaced 12 rotor diameters apart—68% more than compact arrangements. Guide vanes boost output by 80–120%, and interior turbines respond most strongly to spacing, governing overall array performance. ABSTRACT Highway‐induced
Aydin Ulus, Stefan Ilie Moldovan
wiley   +1 more source

Study on sediment erosion of pump turbine guide vane head with V-shaped structure [PDF]

International Journal of Fluid Engineering
During pump turbine operation, sediment particles typically erode and damage the surface of the guide vanes. In this study, Euler–Lagrange numerical calculations and sediment erosion tests are employed to comprehensively analyze the wear characteristics ...
Jiayang Pang, Dandan Yan, Jialing Li, Lingjiu Zhou, Xiaobing Liu, Zhengwei Wang   +5 more
doaj   +1 more source

Guide Vane (Gv) Governor Valve Plta Cikalong Unit 3

, 2021
Hydro Power Plant or Pembangkit Listrik Tenaga Air (PLTA) is a power plant that uses renewable energy in the form of water. The Hydropower System converts the energy from flowing water into mechanical energy and then into electrical energy.
et. al., Ase Suryana,
core   +1 more source

Intrafraction motion and impact of margin reduction for MR‐Linac online adaptive radiotherapy for pancreatic cancer treatments

Journal of Medical Radiation Sciences, Volume 72, Issue 1, Page 17-24, March 2025.
This analysis included quantification of intrafraction motion in pancreas stereotactic ablative radiotherapy treated on the MR‐Linac, leading to the development of adjusted (PTV) margins. Intrafraction motion indicated an average target displacement of 1–3 mm, resulting in an adjusted PTV margin of 2 mm in the right–left and superior–inferior ...
Ashleigh Fasala, Madeline Carr, Yolanda Surjan, Parmoun Daghigh, Jeremy de Leon, Abbey Burns, Vikneswary Batumalai   +6 more
wiley   +1 more source

Cononsolvency‐Assisted Fabrication of Hydrogels and Microgels With Tunable Porosity, Diffusivity and Stiffness

Macromolecular Rapid Communications, EarlyView.
The cononsolvency of poly(dimethyl acrylamide‐co‐hydroxyethyl acrylamide) copolymers in water‐acetonitrile mixtures enables the synthesis of hydrogels with finely tuned porosity. Optimized for droplet‐based microfluidics, this approach facilitates the fabrication of porous microgels with tunable mechanical and diffusion properties, offering precise ...
Maria I. Pieper, Daniel D. Stöbener, Bernhard Häßel, Richard Hoogenboom, Andrij Pich   +4 more
wiley   +1 more source

Behavior of Injection‐Molded Nylon 6 Composites With Virgin and Field‐Exposed Waste‐Recycled Blends

Polymer Composites, EarlyView.
Recycling field‐exposed Nylon 6 composites for sustainable secondary applications. ABSTRACT Every year, more than 18,600 metric tonnes of glass fiber‐reinforced Nylon 6 composite waste from sucker rod guides used in downhole oil and gas applications are landfilled due to uncertainty about retained performance after prolonged service exposure.
Chundu Gyem Tamang, Allan Manalo, Paulomi (Polly) Burey, Wahid Ferdous, Tristan Shelley, Mayur Patel, Tony Chapman   +6 more
wiley   +1 more source

INVESTIGASI RASIO PANJANG INLET GUIDE VANE DAN DUCTING DENGAN ANALISA NUMERIK TERHADAP POLA ALIRAN DAN KECEPATAN KELUARAN OUTLET DUCTING

Jurnal Teknik Mesin, 2020
In this research, air flowing from condenser of cold room has been used to turning turbine through ducting. In term of installation the guide vane in the ducting, air flowing is directed to turbine blade.
fajar anggara
doaj   +1 more source