Results 81 to 90 of about 86,062 (308)
Large plate monitoring using guided ultrasonic waves
, 2015 Areas of stress concentration around welded structures are likely to lead to fatigue cracks and corrosion pitting during the life time of technical machinery.
Ghandourah, EII
core
Fiber-Optic Sensor-Based Remote Acoustic Emission Measurement in a 1000 °C Environment
Sensors, 2017 Recently, the authors have proposed a remote acoustic emission (AE) measurement configuration using a sensitive fiber-optic Bragg grating (FBG) sensor. In the configuration, the FBG sensor was remotely bonded on a plate, and an optical fiber was used as ...
Fengming Yu, Yoji Okabe
doaj +1 more source
Precipitation Simulations of the O‐Phase in Ti2AlNb Alloys Processed by Laser Powder Bed Fusion
Advanced Engineering Materials, EarlyView.Simulated and experimental evolution of the O‐phase volume fraction during postprocessing of a Ti‐21Al‐25Nb (at.%) alloy processed by laser powder bed fusion. With results of sensitivity to input parameters from a thorough and quantified analysis, the interfacial energy matrix/precipitate is the most relevant input parameter for the simulation of the O‐
Silvana Tumminello +7 more
wiley +1 more source
A Dislocation Perspective on Strength and Toughness in Ceramics
Advanced Engineering Materials, EarlyView.Dislocations in ceramics enjoy a long but yet under‐appreciated history. The three research waves for dislocations in ceramics highlight the topic evolution over the last 90 years. This review focuses on the impact of dislocation on strength and toughness in ceramics.
Xufei Fang
wiley +1 more source
Dispersion behavior of torsional guided waves in a small diameter steel gas pipe
, 2013 Condition monitoring of gas pipes has been an important issue for gas companies. Failure to accurately identify condition of gas pipes result in numerous problems. Also, producing a condition monitoring system for buried pipelines is challenging.
Humphrey, V. +2 more
core
On the scattering of torsional elastic waves from axisymmetric defects in coated pipes [PDF]
, 2012 This is the post-print version of the Article - Copyright @ 2012 ElsevierLong range ultrasonic testing is now a well established method for examining in-service degradation in pipelines.
Mudge, P, Zlatev, Z, Kirby, R
core +1 more source
A Graphical Analysis Method of Guided Wave Modes in Rails
Applied Sciences, 2019 The cross-section of a rail has a complex geometry, and there are many propagating modes of ultrasonic guided waves in a rail. The analysis of mode shapes or the cross-sectional wave structure is of high significance to the design of an appropriate wave ...
Xining Xu +4 more
doaj +1 more source
Applied Sciences, 2020 The use of mechanic waves for assessing structural integrity is a well-known non-destructive technique (NDT). The ultrasound applied in the guided wave in particular requires significant effort in order to understand the complexities of the propagation ...
Eduardo Becker Groth +4 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Sol–gel‐derived ZnO–rGO hybrid nanoparticles enable Al7075 powder‐metallurgy composites to achieve concurrent gains in hardness and thermal conductivity while markedly lowering friction and wear. The hybrid architecture couples ZnO‐based load support with rGO‐assisted lamellar sliding and heat spreading, revealing a promising route toward lightweight ...
Bunyamin Aksakal +3 more
wiley +1 more source
Sensors, 2014 The non-contact magnetostrictive sensor (MsS) has been widely used in the guided wave testing of pipes, cables, and so on. However, it has a disadvantage of low excitation efficiency.
Pengfei Sun +3 more
doaj +1 more source