Results 151 to 160 of about 329,894 (240)

Digital geometry capture and stability‐based reuse classification of structural steel

open access: yesce/papers, Volume 9, Issue 2-3, Page 74-79, September 2026.
Abstract This paper presents an integrated visual, geometric, and mechanical assessment framework in which reuse potential is governed by measured geometry. Reclaimed steel profiles from a demolition project were assessed through visual inspection, manual measurement, high‐resolution 3D scanning, and tensile and compression testing.
Niamh Gallagher   +4 more
wiley   +1 more source

Structural performance benefits of Modular Construction Optimised beams compared with conventional Cold‐formed Steel sections.

open access: yesce/papers, Volume 9, Issue 2-3, Page 2415-2420, September 2026.
Abstract Cold‐formed steel (CFS) has become a key material in modular construction due to its high strength‐to‐weight ratio and ease of prefabrication. However, conventional CFS beam profiles are not optimised for the specific demands of modular systems, where concentrated loads, service integration and transportability create critical design ...
Jack Lifsey   +6 more
wiley   +1 more source

Applied Element Modelling of Out‐Of‐Plane Instability in Boundary Elements of Thin RC Walls

open access: yesEarthquake Engineering &Structural Dynamics, Volume 55, Issue 11, Page 2800-2817, September 2026.
ABSTRACT Recent earthquakes in Chile (2010) and New Zealand (2011) caused extensive damage to buildings featuring reinforced concrete (RC) structural walls, with observed failure modes including out‐of‐plane instability of slender walls. This buckling‐type response under combined in‐plane and out‐of‐plane loading has also been documented in ...
Andrea Orgnoni   +2 more
wiley   +1 more source

Functional alignment in robotic total knee arthroplasty provides favourable outcomes and minimal early revisions: A systematic review and meta‐analysis

open access: yesKnee Surgery, Sports Traumatology, Arthroscopy, Volume 34, Issue 9, Page 3362-3376, September 2026.
Abstract Purpose Functional alignment (FA) has emerged as a personalised alignment strategy in total knee arthroplasty (TKA), enabled by robotic‐assisted technology. Although early clinical results are encouraging, evidence remains heterogeneous and long‐term safety is uncertain.
Vasileios Giovanoulis   +6 more
wiley   +1 more source

Experimental and Comparative Study of the Corrosion Behavior of Lean Duplex Stainless Steel in Seawater

open access: yesMaterials and Corrosion, Volume 77, Issue 9, Page 1399-1423, September 2026.
The localized corrosion behavior of lean duplex stainless steel EN 1.4062 is systematically compared with austenitic and higher‐alloyed duplex grades in natural seawater. A clear resistance ranking is established, highlighting EN 1.4062 as a cost‐effective alternative for limited marine exposure.
Mohammad Hassanzadeh   +4 more
wiley   +1 more source

EUS‐Guided Choledochoduodenostomy With Lumen‐Apposing Metal Stents: A Recommendation From an Expert Delphi Consensus

open access: yesUnited European Gastroenterology Journal, Volume 14, Issue 7, September 2026.
ABSTRACT Background and Aims Endoscopic ultrasound‐guided choledochoduodenostomy with a lumen apposing metal stent (EUS‐CDS‐L) is an increasingly utilized therapeutic option for biliary drainage. However, numerous procedural and periprocedural factors may influence technical and clinical outcomes.
Tawfik Khoury   +32 more
wiley   +1 more source

Home - About - Disclaimer - Privacy