Results 191 to 200 of about 905,961 (285)

River channel restoration: guiding principles for sustainable projects

Revista Geographia, 2010
Sandra Baptista da Cunha
doaj   +1 more source

Integrating competency-based, interprofessional teamwork education for students: guiding principles to support current needs and future directions. [PDF]

Front Med (Lausanne)
Williams KN, Lazzara EH, Hernandez J, Klocko D, Chandran N, Paquette SL, Preble R, Sadighi M, Tran B, Kilcullen M, Rege R, Reed G, Salas E, Tannenbaum SI, Greilich PE.   +14 more
europepmc   +1 more source

Characterization of Nitinol Produced by Laser Powder Bed Fusion for Mechanical Metamaterial Applications

Advanced Engineering Materials, EarlyView.
Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek, Jakub Hurník, Miroslav Šmíd, Ondřej Zobač, Melanie Todt, Daniel Koutný   +5 more
wiley   +1 more source

Guiding principles and considerations for designing a well-structured curriculum for the brain-computer interface major based on the multidisciplinary nature of brain-computer interface. [PDF]

Front Hum Neurosci
Yang H, Li T, Zhao L, Wei Y, Chen X, Pan J, Fu Y.   +6 more
europepmc   +1 more source

Handbook of Establishing and Maintaining Oxygen‐Free Atmospheres

Advanced Engineering Materials, EarlyView.
This study presents a practical framework for creating oxygen‐free atmospheres at ambient pressure using silane‐doped inert gases. The results show that ultra‐low oxygen levels and strongly reduced water content can be achieved through controlled silane dosing, drying systems, and sensor monitoring.
Sascha Jan Zimmermann, René Gustus, Lienhard Wegewitz, Wolfgang Maus‐Friedrichs   +3 more
wiley   +1 more source

Effect of Oxygen Content on Surface and Subsurface Integrity During Turning of Ti–6Al–4V

Advanced Engineering Materials, EarlyView.
This study examines how oxygen content in the ambient atmosphere affects the surface and subsurface properties of Ti–6Al–4V during turning. Results show that oxygen does not influence surface roughness. However, machining in an extremely high vacuum‐adequate atmosphere increases surface hardness by up to 7.8% and induces compressive residual stresses ...
Benjamin Bergmann, Berend Denkena, Hilke Petersen, Florian Schaper   +3 more
wiley   +1 more source

Maximising Embedded Pharmacists in AGed CAre Medication Advisory Committees (MEGA-MAC): protocol for implementing Australia's new guiding principles for medication management in residential aged care facilities using knowledge brokers and a national quality improvement collaborative. [PDF]

Implement Sci
Cross AJ, Blakeley B, Laver K, Haines TP, Hilmer SN, Manek A, Bennett A, Martini A, Martini A, Quirke L, Kulh MA, Whittaker SL, Cenin DR, Hobbs A, Money J, Rieniets K, Salisbury K, Yong ASJ, Bell JS.   +18 more
europepmc   +1 more source

Air‐Pressure–Actuated Vibroacoustic Metamaterial With Tunable Bandgap: Design, Modeling, and Characterization

Advanced Engineering Materials, EarlyView.
This article presents the design, modeling, and characterization of air‐pressure–actuated programmable vibroacoustic metamaterials (PVAMM). The study focuses on leveraging air pressure to dynamically tune resonance frequencies for effective noise attenuation.
William Kaal, Michael M. Becker, Sarah C. L. Fischer   +2 more
wiley   +1 more source

Guiding Principles for Writing About Immigrants and Immigrant Health. [PDF]

J Immigr Minor Health
Saadi A, Marzoughi M, Kimball SL.
europepmc   +1 more source

Composition‐Tuned Enhancement of the Anomalous Nernst Effect in FeCo–Pt Thin Films on Rigid and Flexible Substrates

Advanced Engineering Materials, EarlyView.
Disordered (Fe50Co50)1−xPtx thin films exhibit a pronounced anomalous Nernst effect (ANE) with a strong composition dependence on both rigid and flexible substrates. The transverse thermoelectric response peaks near 22.5 at.% Pt, accompanied by enhanced αxy/σxy scaling, thermal transport, and ANE sensitivity.
Mojtaba Mohammadi, Hiroyuki Awano, Kenji Tanabe   +2 more
wiley   +1 more source