Results 141 to 150 of about 15,963,312 (351)
Studies on fatigue behaviour of weld-bonds of Al-Mn-Mg alloy [PDF]
, 2013 In the present paper, fatigue and metallurgical behaviour of weld-bonds and adhesive bonds developed using 2 mm thick aluminium alloys namely 5052 alloy have been reported. Weld-bonds were prepared using structural adhesive (Epoxy resin) and spot welding
Dwivedi, Dheerendra, Mittal, Mayank
core
Advanced Engineering Materials, EarlyView.Nickel‐based alloys are widely used in high‐temperature applications due to their excellent mechanical strength and oxidation resistance. However, properties such as high‐temperature strength and pronounced work‐hardening make them difficult to machine.
Soheil Rooein +2 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.The presented study focuses on the fracture behaviour of carbon‐bonded magnesia MgO–C refractories, where environmentally friendly fructose, collagen and lignin serve as temporary binding agents. The partial substitution of the source material with recycled MgO–C reduces the fracture resistance, which can be counteracted by the additional introduction ...
Marc Neumann +6 more
wiley +1 more source
DETERMINATION OF ELECTRODEPOSITION HARDNESS BY ANALYTICAL MODELING PART II - Ni-P/SiC COATINGS OBTAINED BY VARYING THE ELABORATION TIME- [PDF]
Fiabilitate şi Durabilitate, 2012 Buckle and Jönsson - Hogmark analytical models have been applied to determine the Ni-P/SiC composite electrodeposition hardness obtained by varying development time.
PASĂRE Minodora Maria, NICA BADEA Delia
doaj
Industrial Data, 2001 The hardness test is, together with the administration of one of the most used in the selection and quality control of materials ...
Santos De la Cruz, Eulogio +3 more
openaire +1 more source
Advanced Engineering Materials, EarlyView.Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source
Influence of an Oxygen‐Free Atmosphere on Diamond‐Single‐Grain Scratching of Ti–6Al–4V
Advanced Engineering Materials, EarlyView.Single‐grain scratching of Ti–6Al–4V is investigated under controlled, oxygen‐free, and ambient atmospheres using a novel experimental setup with in situ high‐speed imaging. The approach enables direct observation of chip formation and adhesion under suppressed oxidation.
Berend Denkena +2 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.The formation of nonmetallic inclusions (NMIs) was investigated in this study, carrying out immersion tests for 30 min at a temperature of 1600°C with liquid high‐silicon electrical steel (Si ≈ 3 mass‐%) and different MgO–C refractories. Conventional MgO–C refractories were considered, as well as MgO–C refractories containing MgO–C recyclate and ...
Lukas Neubert +6 more
wiley +1 more source
Assessing Altered Coating Adhesion on Plasma‐Deoxidized Surfaces Under Oxygen‐Free Conditions
Advanced Engineering Materials, EarlyView.This study demonstrates the effectiveness of atmospheric pressure plasma pretreatment in modifying silicon and stainless steel surfaces to improve adhesion. Argon‐hydrogen plasma increases surface roughness and improves adhesion strength, whereas pure argon results in smoother surfaces and structural changes.
Selina Raumel +6 more
wiley +1 more source