Harmonic Analysis of Large Grid-Connected PV Systems in Distribution Networks: A Saudi Case Study
International Journal of Photoenergy, 2022 The increasing penetration of grid-connected PV rooftops at the distribution level still entails significant technical challenges affecting seriously the power quality indices such as harmonics and voltage fluctuations.
Yahya M. Al-Sharif +2 more
doaj +1 more source
Harmonics Measurement, Analysis, and Impact Assessment of Electric Vehicle Smart Charging
IEEE Open Journal of Vehicular TechnologySmart charging for Electric Vehicles (EVs) is gaining traction as a key solution to alleviate grid congestion, delay the need for costly network upgrades, and capitalize on off-peak electricity rates.
Murat Senol +7 more
doaj +1 more source
Geomagnetically Induced Currents and Harmonic Distortion: Storm‐Time Observations From New Zealand
Space Weather, 2020 Large geomagnetic storms are a known space weather hazard to power transmission networks due to the effects of geomagnetically induced currents (GICs). However, research in this area has been hampered by a lack of GIC observations.
Craig J. Rodger +10 more
doaj +1 more source
Standards of distorted signal for calibration of total harmonic distortion meters [PDF]
1998 Conference on Precision Electromagnetic Measurements Digest (Cat. No.98CH36254), 2002 In this article a survey and evaluation of some progressive approaches to the standards of non-linear distortion is reported. Some types of standards of signals with the known total harmonic distortion used for calibration of distortion measuring instruments are proposed.
openaire +3 more sources
EnergiesThis paper proposes a novel nine-phase ferrite-assisted synchronous reluctance machine (FA-SynRM) featuring skewed stator slots to address challenges related to harmonic distortion, torque ripple, and material sustainability which are prevalent in ...
Hongliang Guo +4 more
doaj +1 more source
Application of PI controller based DSTATCOM for improving the power quality in a power system network with induction furnace load [PDF]
Songklanakarin Journal of Science and Technology (SJST), 2012 This paper presents the application of DSTATCOM in a distribution network with induction furnace load. Inductionfurnace is one of the common types of load used in industries like the steel industry.
Parag Nijhawan1 +2 more
doaj
Multi-Point Time-Synchronized Waveform Recording for the Analysis of Wide-Area Harmonic Propagation
Applied Sciences, 2020 This paper focuses on studying the phenomenon of harmonic distortion propagation through distribution networks. This phenomenon is governed by a combination of factors involving the nature of harmonic loads and their dynamic interaction, the influence of
Stanislav Babaev +4 more
doaj +1 more source
Design of mine-used single-phase harmonic suppression system
Gong-kuang zidonghua, 2016 In view of problem of severe distortion of local current wave caused by increase of low-voltage single-phase electrical equipment, a kind of single-phase harmonic suppression system used in low-voltage system was designed.
LUO Shuke
doaj +1 more source
A novel hybrid PWM algorithm having superior harmonic performance
Ingeniería e Investigación, 2009 This paper presents a novel hybrid modulation algorithm which improves the harmonic performance of eight of the most common pulse width modulation (PWM) algorithms for voltage source inverters (VSI) in the electric drive field. From harmonic a-nalysis of
Diana Jimena López Mesa +4 more
doaj
Passive Filter Design for Improving Quality of Solar Power
International Journal of Electrical, Energy and Power System Engineering, 2018 With the progress of industry, power electronic equipment is widely used in power system, it has produced serious harmonic distortion. It goes without saying that harmonic analysis is a very important subject in power system.
Nurhalim Dani Ali +4 more
doaj +1 more source