Results 101 to 110 of about 1,002,790 (325)
Advanced Functional Materials, EarlyView.Guided by the golden ratio, a class of aperiodic architected metamaterials is introduced to address the intrinsic trade‐off between strength and toughness. By unifying local geometric heterogeneity with global order, the golden‐ratio‐guided aperiodic architecture promotes spatial delocalization of damage tolerence regions, leading to more tortuous ...
Junjie Deng +9 more
wiley +1 more source
Continuous harmonic impedance assessment using online measurements
2015 IEEE International Workshop on Applied Measurements for Power Systems (AMPS), 2015 The quantification of harmonic emission requires an accurate representation of the network harmonic impedances. A number of techniques have been proposed to make the assessment of the network harmonic impedances practical and less invasive. Using actual event data, captured at a solar farm, this paper aims to utilize existing assessment techniques to ...
Serfontein, Duan +3 more
openaire +3 more sources
Effect of transmitter position on the torque generation of a magnetic resonance based motoring system [PDF]
, 2019 Strongly coupled magnetic resonance is most often used to transfer electrical power from a transmitter to a resonant receiver coil to supply devices over an air gap.
Crevecoeur, Guillaume +2 more
core +1 more source
Advanced Functional Materials, EarlyView.The pyrene and ether groups are incorporated into the covalent triazine polymer (CTP) structure. The synergistic effect of the two functional groups endows CTP with better electron transfer, light absorption, and oxygen activation properties. An impressive apparent quantum yield (13.2% @420 nm) and a remarkable solar‐to‐chemical conversion efficiency ...
Chong Wang +10 more
wiley +1 more source
Nonlinear mechanisms in passive microwave devices [PDF]
, 2011 Premi extraordinari doctorat curs 2010-2011, àmbit d’Enginyeria de les TICThe telecommunications industry follows a tendency towards smaller devices, higher power and higher frequency, which imply an increase on the complexity of the electronics ...
Rocas Cantenys, Eduard
core +4 more sources
Growth of Millimeter‐Sized BaTaO2N Single Crystals by an NH3‐Assisted BaCl2 Flux Method
Advanced Functional Materials, EarlyView.Millimeter‐sized BaTaO2N single crystals are successfully grown from a BaCl2 flux under NH3 flow. Their comprehensive characterization, including dielectric properties, is demonstrated, and the possible growth mechanisms are discussed. Abstract Perovskite‐type oxynitrides have attracted considerable attention due to their excellent photocatalytic ...
Ginji Harada +2 more
wiley +1 more source
Analysis of harmonics in subsea power transmission cables used in VSC-HVDC transmission systems operating under steady-state conditions [PDF]
, 2007 Subsea power cables are a critical component of a voltage-source converter-high-voltage direct current (VSC-HVDC) transmission system in any offshore electrical power scheme.
Bucknall, R.W.G., Chien, C.H.
core
Cost-effective applications of power factor correction for nonlinear loads [PDF]
, 2005 This material is posted here with permission of the IEEE. Such permission of the IEEE does not in any way imply IEEE endorsement of any of Brunel University's products or services. Internal or personal use of this material is permitted.
Zobaa, AF
core +1 more source
Advanced Functional Materials, EarlyView.Photomultiplication organic photodetectors (PM OPDs) are an attractive strategy for health‐monitoring. Here, PM‐OPDs are reported with a specific detectivity of 5.7 × 1012 Jones and external quantum efficiency values of 3500% under −10 V. The dynamics of carrier trapping in these devices are elucidated through trap selective spectroscopical techniques.
Marie Houot +9 more
wiley +1 more source
Advanced Functional Materials, EarlyView.A FeN4─O/Clu@NC‐0.1Ac catalyst containing atomically‐dispersed FeN4─O sites (medium‐spin Fe2+) and Fe clusters delivered a half‐wave potential of 0.89 V for ORR and an overpotential of 330 mV at 10 mA cm−2 for OER in 0.1 m KOH. When the catalyst was used in a rechargeable Zn–air battery, a power density of 284.5 mW cm−2 was achieved with excellent ...
Yongfang Zhou +8 more
wiley +1 more source