Results 131 to 140 of about 149,415 (317)
Single-phase flow and flow boiling of water in horizontal rectangular microchannels [PDF]
, 2013 This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel UniversityThe current study is part of a long term experimental project devoted to investigating single-phase flow pressure drop and heat transfer, flow boiling ...
Mirmanto
core
Flow maldistribution in industrial air heaters and its effect on heat transfer
, 2014 Flow maldistribution in cross-flow heat exchangers used for industrial air heaters or recuperators is fairly common and can lead to a number of undesirable effects, one of which is deterioration in the thermal performance.
Walmsley, Michael R.W. +4 more
core +1 more source
Advanced Engineering Materials, EarlyView.A combined experimental–computational framework identifies energy‐dependent laser absorptivity for NiTi in laser powder‐bed fusion, applicable to conduction and transition modes. Single‐track experiments and thermofluid smoothed particle hydrodynamics simulations are coupled through inverse analysis of melt pool geometry.
Mohamadreza Afrasiabi +3 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study applies machine learning regression to predict chromium layer thickness in decorative trivalent chromium electroplating, using 441 experiments from laboratory‐scale (1L) and pilot‐scale (14L) setups. Tree‐based models, particularly CatBoost, outperformed linear regression by capturing nonlinear parameter interactions (R2$R^2$ up to 0.77 ...
Christoph Baumer +4 more
wiley +1 more source
Boiling Heat Transfer of R-1234yf in Horizontal Circular Small Tubes
, 2012 An experimental study for heat transfer coefficient and pressure drop with two-phase flow phase change was conducted with R-1234yf in horizontal circular small tubes.
Oh, Jong-Taek +3 more
core
Advanced Engineering Materials, EarlyView.Si‐doped AlCoCrFeNi high‐entropy alloys are synthesized by mechanical alloying to reveal the effect of Si content and milling time on phase evolution, microstructural refinement, and tribological behavior. A transition from FCC to BCC structure, significant grain refinement, and enhanced hardness and wear resistance are achieved, with the 4 at% Si ...
Mustafa Okumuş +2 more
wiley +1 more source
Cooling of high-power-density computer components [PDF]
, 1968 This report summarizes work carried out during the first two years of a research program sponsored by IBM Corporation. This study has elucidated a number of the heat-transfer characteristics of several fluorochemicals which have potential application as ...
Bakhru, N. +2 more
core
Advanced Engineering Materials, EarlyView.Sol–gel‐derived ZnO–rGO hybrid nanoparticles enable Al7075 powder‐metallurgy composites to achieve concurrent gains in hardness and thermal conductivity while markedly lowering friction and wear. The hybrid architecture couples ZnO‐based load support with rGO‐assisted lamellar sliding and heat spreading, revealing a promising route toward lightweight ...
Bunyamin Aksakal +3 more
wiley +1 more source
Heat and Mass Transfer in Recirculating Flows [PDF]
International Journal of Heat and Mass Transfer, 1970 openaire +1 more source
, 2012 In the CO2 heat pump system, Poly alkyl glycol (PAG) oil is commonly used for lubrication of the compressor, while it is reported that the PAG oil has influence on the heat transfer performance due to its immiscibility against CO2 within its working ...
Fujino, Hirokazu +2 more
core