Results 21 to 30 of about 262,009 (305)
OPTIMIZATION OF AERODYNAMIC CONDITIONS OF THE CHAMBER DRIER OPERATION
Известия высших учебных заведений и энергетических объединенний СНГ: Энергетика, 2016 Wood utilization is a critical direction of the industrial production advancement, where desiccation of wood holds a prominent place. Convective drying in chamber driers is the presentday dominant technique for wood desiccation.
V. A. Sychevsky +2 more
doaj +1 more source
Приборы и методы измерений, 2023 The influence of temperature in the range from 20 to 100 °C on the specific surface energy and fracture toughness of standard silicon wafers of three orientations (100), (110) and (111) was studied.
V. A. Lapitskaya +2 more
doaj +1 more source
New Advancements in Heat and Mass Transfer: Fundamentals and Applications
, 2023 Heat and mass transfer, widely involved in various energy systems, has great impacts on the safety, efficiency, as well as performance of these systems [...
Guojun Yu, Huihao Liu, Huijin Xu
core +1 more source
Power‐law multi‐wave model for COVID‐19 propagation in countries with nonuniform population density
Quantitative Biology, 2022 Background The purpose of our study is to develop a quite precise mathematical model which describes epidemics spread in a country with non‐uniform population density.
Pavel Grinchuk, Sergey Fisenko
doaj +1 more source
Study of a laminar falling film flowing over a wavy wall column: Part I. Numerical investigation of the flow pattern and the coupled heat and mass transfer [PDF]
, 2001 Flow pattern and heat and mass transfer characteristics for a film flowing over a vertical wavy column are numerically investigated in a laminar flow regime.
Prevost, Michel +5 more
core +1 more source
Physical and Mathematical Models of Micro-Explosions: Achievements and Directions of Improvement
Energies, 2023 The environmental, economic, and energy problems of the modern world motivate the development of alternative fuel technologies. Multifuel technology can help reduce the carbon footprint and waste from the raw materials sector as well as slow down the ...
Dmitrii V. Antonov +3 more
doaj +1 more source
Ignition Delay and Reaction Time Measurements of Hydrogen–Air Mixtures at High Temperatures
FireInduction and reaction times of hydrogen–air mixtures (ϕ = 0.5–2) have been measured behind reflected shock waves at temperatures of 1000–1600 K, pressures of 0.1, 0.3, 0.6 MPa in the domain of the extended second explosion limit.
Yauhen Baranyshyn +3 more
doaj +1 more source
Applied Sciences, 2020 This paper presents the results of analyzing the efficiency of the following five fuel types: dry coal, wet coal processing waste, coal–water slurry, and two waste-derived slurries.
Ksenia Vershinina +4 more
doaj +1 more source
, 2010 Heat transfer by natural convection in triangular enclosures is an area of significant importance in applications such as the design of greenhouses, attics and solar water heaters.
Carson, James K. +2 more
core +1 more source
Doped and Decorated Carbon Nanomaterials
Eurasian Chemico-Technological Journal, 2015 This work shows the preliminary results concerning to the synthesis or modification of carbon-based nanomaterials by plasma discharge, magnetron sputtering, and chemical vapor deposition methodologies.
J. Matos +6 more
doaj +1 more source