Results 151 to 160 of about 262,009 (305)

Cathodic Cage Plasma Deposition of Nanostructured Cu–Fe–Se Coatings on Poly(methyl Methacrylate)

open access: yesAdvanced Engineering Materials, EarlyView.
Nanostructured Cu–Fe–Se coatings are deposited on PMMA by a modified cathodic cage plasma process, enabling low‐temperature deposition on polymer substrates. A transition from discontinuous to compact morphology is observed with temperature, with optimal properties at 200°C, where improved CuFeSe2‐type bonding, lowest sheet resistance, and favorable ...
V. S. S. Sobrinho   +8 more
wiley   +1 more source

Simultaneous Heat and Mass Transfer in a Wetted Heat Exchanger, Part I: Experiments

open access: yes, 2012
Using an induced open-loop wind tunnel and a full cone water spray nozzle, the performance of a brazed aluminum heat exchanger with louvered fins is studied experimentally for wet conditions.
Jacobi, Anthony M.   +3 more
core   +1 more source

Experimental Study on Flow Boiling Heat Transfer of Zeotropic Mixture R290/R601a in a Mini-Channel

open access: yes
The flow boiling heat transfer characteristics of zeotropic mixture R290/R601a in a horizontal mini-channel with an inner diameter of 2 mm were experimentally studied.
Dechang Wang   +4 more
core   +1 more source

Natural Bone‐Derived Ceramic Scaffolds Functionalized with Chitosan‐Gold, Chitosan‐Magnesium, and Chitosan‐Zinc for Enhanced Antibacterial Activity

open access: yesAdvanced Engineering Materials, EarlyView.
This study reports the development of antibacterial ceramic scaffolds derived from natural bovine bone. The bones were processed through sequential boiling and hydrogen peroxide treatment to remove organic matter, producing porous, mineral‐rich scaffolds.
Mohamad Hassan Taherian   +6 more
wiley   +1 more source

Effect Of Operational Parameters On Heat and Mass Transfer In Generator of R134a/DMF Absorption Refrigeration System

open access: yes, 2012
Vapour absorption refrigeration systems (VARS) has regained the attention due to their potential for renewable/waste heat utilization. To improve the efficiency of these systems, it becomes obligatory to make component level studies on processes. In this
Pasupathy, Balamurugan, Annamalai, Mani
core   +1 more source

Encyclopedia of 2D β′‐In2Se3 Growth Using Chemical Vapor Deposition: The Effects of Synthesis Parameters Onto Material Quality

open access: yesAdvanced Engineering Materials, EarlyView.
A distinct semi‐confined inner‐tube chemical vapor deposition geometry enables reproducible, large‐area growth of phase‐pure 2D β′‐In2Se3 from InI + Se precursors. Engineering local vapor transport and optimizing precursor delivery and temperature–time conditions yield uniform continuous films.
Dasun P. W. Guruge   +8 more
wiley   +1 more source

Influence of Surface Finish on the Tribological Performance of AlTiBN Coatings Deposited on Forming Tools

open access: yesAdvanced Engineering Materials, EarlyView.
Aluminum and nitride coatings are used in industry because they are hard, resist wear, and protect against oxidation. Adding boron can improve friction behavior and other properties. This study tests coatings on surfaces with different finishes. Results show smoother surfaces perform better, while rough ones wear faster, although coatings can reduce ...
Adrián Claver   +9 more
wiley   +1 more source

MHD heat and mass transfer of a ternary hybrid nanofluid over a rotating sphere. [PDF]

open access: yesDiscov Nano
Obalalu AM   +4 more
europepmc   +1 more source

Home - About - Disclaimer - Privacy