Results 211 to 220 of about 3,219,487 (379)
Advanced Engineering Materials, EarlyView.A two‐step approach combining laser powder bed fusion of FeSi electrical steel with Bakelite infiltration enables the fabrication of multifunctional gyroid lattice composites. The resulting structures exhibit high strength, magnetic anisotropy, and complete polymer infiltration, demonstrating a simple and scalable route toward lightweight, mechanically
Angelo F. Andreoli +9 more
wiley +1 more source
Carnot Cycle and Heat Engine: Fundamentals and Applications. [PDF]
Entropy (Basel), 2020 Feidt M.
europepmc +1 more source
Advanced Engineering Materials, EarlyView.Triphasic BiFeO3–PbZr0.58Ti0.42O3–MnFe2O4 composites exhibit enhanced ferroelectric and magnetic behavior, achieving 70.76% energy‐storage efficiency and improved polarization switching. The coupling between ferroelectric and magnetic phases enables multifunctional performance, making these composites promising candidates for next‐generation energy ...
Hassan Raza Khan +7 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source
3D Bioprinting of Thick Adipose Tissues with Integrated Vascular Hierarchies
Advanced Functional Materials, Volume 35, Issue 12, March 18, 2025.An advanced 3D bioprinting technique is used here to create thick adipose tissues with a central, vessel and extensive branching. The construct is made using alginate, gelatin and collagen‐based bioinks. Flow through the complex vessel network is demonstrated as well as its successful integration with a femoral artery following implantation in a rat ...
Idit Goldfracht +5 more
wiley +1 more source
Harvesting Waste Heat Energy from Automobile Engine Exhaust Using Teg with Heat Pipes
, 2018 Arun Balakrishnan +3 more
openalex +1 more source
Advanced Functional Materials, EarlyView.Graded refractive index (GRI) structures are prepared from the layer‐by‐layer spray coating of the mesoporous SiO2 nanoparticles, showing high solar transparency and thermal emissivity. Under outdoor conditions, after 50 days, the GRI‐coated photovoltaics show on average 6.65 ± 1.48 °C lower than that of the non‐coated references, maintaining 80.9 ± 8 ...
Heesuk Jung +14 more
wiley +1 more source
Advanced Functional Materials, Volume 35, Issue 12, March 18, 2025.A high‐performance n‐type element for quasi‐solid‐state thermocells has been introduced, outperforming conventional p‐type elements and showcasing the potential to harness body heat as an energy source or power embedded sensors. This advance significantly contributes to waste thermal energy harvesting and wearable technology, paving the way for self ...
Gilyong Shin +10 more
wiley +1 more source