Results 21 to 30 of about 1,096,222 (292)
International Journal of Electrochemical Science, 2021 A bulk multilayer nanostructured Ni-Co alloy with nano-grains (NG) layer with a thickness of 2.7μm and ultrafine grains (UFG) layer with a thickness of 0.9μm alternately grown is fabricated by an electrodeposition process.
Xiaoxue Zhang, Xixun Shen, Jiawen Chen
doaj +1 more source
Research on the Ratio between the Convection and Radiation Heat Exchange Amount of the Face and Head of Manikin in the Thermal Comfort Condition [PDF]
E3S Web of Conferences, 2022 In this paper, the radiation heat exchange coefficient of the exposed parts of human body is firstly obtained through pre-experiment, which is used to separate the total output heat exchange amount of the manikin. Then the heat exchange amount of manikin
Yang Xinwei +5 more
doaj +1 more source
Computational parametric study on efficiency of low boiling point fluid plants under heat exchange process intensification [PDF]
E3S Web of Conferences, 2021 One of the main challenges for the energy industry is to improve the reliability and efficiency of heat exchange equipment in heating plants. Phase-change heat exchangers with low boiling point fluid (LBPF) are widely used in both conventional and ...
Likhaeva Alena +3 more
doaj +1 more source
Crystals, 2020 Calcium sulfate scale is a typical deposit on the equipment pieces or pipes of an industrial water system. Scale inhibitors could obviously reduce the precipitation of calcium sulfate crystal.
Jian-Qiu Chen +4 more
doaj +1 more source
International Journal of Electrochemical Science, 2021 In this paper, a nitrited chromium composite coating is fabricated as a protective coating for the 316 stainless steels bipolar plates by a combination process of electrodeposition and liquid-phase plasma electrolysis. The pre-treatment of chemical micro
Yaxue Wang +4 more
doaj +1 more source
Mechanics & Industry, 2023 The development of accurate dynamic stiffness models is a key aspect in the design process of ball screws. However, variations in the nut center of mass position can affect the dynamic stiffness, which makes it difficult to develop a stiffness model.
Jin Lan +3 more
doaj +1 more source
Heliyon, 2023 In comparison to methane (CH4), ammonia (NH3) is considered a potential carbon-free alternative fuel that can reduce greenhouse gas emissions. But a principal concern is the generation of elevated nitrogen oxide (NOX) emissions from NH3 flame.
Yunyun Wang +4 more
doaj +1 more source
Journal of Saudi Chemical Society, 2020 Rapid synthesis of 3-arylphthalides with a quaternary carbon center has been achieved via a cascade [4+1] cycloaddition/nucleophilic 1,4-addition of 2-carbonylcyclohexadienimines with two molecules of isocyanides.
Zhihao Du, Qunjie Xu, Guangxin Gu
doaj +1 more source
Shenzhen Daxue xuebao. Ligong ban, 2022 Compared with traditional bored pipe heat exchanger geothermal collection technology, the continuously optimized energy pile technology is more efficient and economical in the application of building energy-saving projects.
CHEN Zhi +4 more
doaj +1 more source
Effect of Carbon Nanoparticles on the Crystallization of Calcium Carbonate in Aqueous Solution
Nanomaterials, 2019 Nanofluids have great application prospects in industrial heat exchange systems because they can significantly improve the heat and mass transfer efficiency.
Chuan Wan +3 more
doaj +1 more source