Results 111 to 120 of about 4,466,317 (351)
A simplified method for determining convective heat-transfer coefficients [PDF]
, 1970 Convective heat transfer coefficients are determined by measuring temperatures of hot and cold fluids separated by wall, and temperature of wall at single point.
Huff, R. G.
core +1 more source
Advanced Engineering Materials, EarlyView.Cladding is a proven method that boosts the surface qualities of mechanical parts by applying a layer of more durable material over a base substrate. This work responds to the needs of offshore and pressure vessels sectors by focusing on cladding a super austenitic steel onto low‐carbon steel through gas tungsten arc welding.
E. J. da Cruz Junior +6 more
wiley +1 more source
Clinics, 2009 OBJECTIVES: To evaluate and compare the efficiency of humidification in available heat and moisture exchanger models under conditions of varying tidal volume, respiratory rate, and flow rate.
Jeanette Janaina Jaber Lucato +5 more
doaj +1 more source
Method of calculation and analysis of joint operation of circuit loop of ground heat exchangers and heat pump [PDF]
, 2013 The method of heat calculation of the joint work of borehole heat exchangers and heat pump circuits in quasi-stationary regime is developed.
Filatov, S. A., Volodin, V. I.
core
Advanced Engineering Materials, EarlyView.Selenium was incorporated into a sol–gel‐derived bioactive glass to enable sustained therapeutic ion release. The selenium‐containing glass preserved bioactivity while selectively inducing cytotoxicity in osteosarcoma cells and maintaining osteoblastic viability.
Breno Rocha Barrioni +7 more
wiley +1 more source
Basic Heat Exchanger Performance Evaluation Method on OTEC
Journal of Marine Science and Engineering, 2018 Ocean thermal energy conversion (OTEC) harvests the power from the thermal energy in the ocean, which is reserved in the ocean as the temperature difference between warm surface and cold deep seawaters.
Takeshi Yasunaga +3 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Cermets (60 vol.% AISI 316L stainless steel, 40 vol.% recycled MgO), intended for use in aluminum electrolysis, were pre‐oxidized in three furnaces with different heating technologies and subjected to a cryolite corrosion test. The different atmospheres influenced the formation of oxide layers, which in turn affected corrosion resistance and ...
Patricia Kaiser +4 more
wiley +1 more source
Energy Efficiency Retrofit of Two-Flow Heat Exchanger System
Chemical Engineering Transactions, 2018 This paper presents the retrofit of the two-flow heat-exchange system with utility paths in order to optimize the heat recuperation capacity under the technical limitation conditions.
Leonid M. Ulyev +3 more
doaj +1 more source
Applied Energy, 2018 Due to the unique geometries and hydraulics of printed circuit heat exchangers and rapidly changing properties of supercritical carbon dioxide, the effective design and rating of printed circuit heat exchangers is an essential requirement for their use ...
Yuan Jiang +3 more
semanticscholar +1 more source
Advanced Engineering Materials, EarlyView.Additive manufacturing provides precise control over the placement of continuous fibres within polymer matrices, enabling customised mechanical performance in composite components. This article explores processing strategies, mechanical testing, and modelling approaches for additive manufactured continuous fibre‐reinforced composites.
Cherian Thomas, Amir Hosein Sakhaei
wiley +1 more source