Results 31 to 40 of about 4,466,317 (351)
Energy saving when using equipment for the disposal of low-potential waste heat [PDF]
E3S Web of ConferencesThe article discusses the problem of energy saving in the context of comparing different types of heat exchangers for the utilization of high-potential waste heat.
Guschin I.A.
doaj +1 more source
Energies, 2020 The creation of efficient and compact heat exchangers is one of the priority tasks arising during the design of heat and gas supply to industrial and residential buildings.
Natalia Rydalina +6 more
doaj +1 more source
Design and analysis of shell and tube heat exchanger
International Journal for Simulation and Multidisciplinary Design Optimization, 2022 The demand for consumption of energy in industries has made designers to build efficient heat transfer exchangers. One of the most used heat exchangers which supports this is the shell and tube heat exchangers which are built for effective heat transfer.
Fernandes Erica Jacqueline +1 more
doaj +1 more source
Thermal analysis and optimization of a heat regenerator composed of two coupled moving bed heat exchangers [PDF]
, 2008 This work presents a study to optimize the performance of a heat regenerator composed by two coupled moving bed heat exchangers (MBHE). A MBHE is used to recover heat, from a hot gas stream, and the other one is used to preheat an air stream.
Almendros Ibáñez, José Antonio +3 more
core +2 more sources
Performance Simulation of Air-ground Hybrid Source Heat Pump Systems in Northern China
Zhileng xuebao, 2021 The air-ground hybrid source heat pump system can realize indirect air source heat pump mode and heat compensation mode through an air-water heat exchanger, which could compensate for the difference between heat extraction and heat injection to the soil.
Wang Wentao, Li Xianting, Hu Pingfang
doaj
Multi-objective optimization of two hybrid power generation systems for optimum selection of SOFC reactants heat exchangers mid-temperatures [PDF]
Hydrogen, Fuel Cell & Energy Storage, 2017 Increasing efficiency and decreasing cost are the main purposes in the design of the power generation systems. In this study two hybrid systems: solid oxide fuel cell (SOFC)-gas turbine (GT) and SOFC-GT-steam turbine (ST); are considered.
saber sadeghi
doaj +1 more source
Engineering Science and Technology, an International Journal, 2023 The heat exchangers are commonly used in thermal power companies, chemical factories, petroleum industries, and etc for the purpose of exchange heat from one fluid to another fluid.
L. Syam Sundar
doaj +1 more source
, 2020 The Hypersonic Precooled Combined Cycle Engine (HPCCE), which introduces precooler into traditional hypersonic engine, is regarded as the most promising propulsion system for realizing a single-stage-to-orbit vehicle.
B. Meng +4 more
semanticscholar +1 more source
Optimization on Scheduling for Cleaning Heat Exchangers in the Heat Exchanger Networks
Chemical Engineering Transactions, 2015 In the process at a plant that incorporating heat integration for energy recovery, fouling or formation of deposits on the heat exchanger often causes operational problems in production. Increasing the energy consumption resulted in higher operating expenses. Expenses can be reduced if the cleaning is done on a regular basis. Therefore, how to schedule
Licindo D., Handogo R., Sutikno J.P.
openaire +2 more sources
Area targeting and storage temperature selection for heat recovery loops [PDF]
, 2012 Inter-plant heat integration across a large site can be achieved using a Heat Recovery Loop (HRL). In this paper the relationship between HRL storage temperatures, heating and cooling utility savings (heat recovery) and total HRL exchanger area is ...
Atkins, Martin John +3 more
core +2 more sources