Results 161 to 170 of about 2,796,382 (285)

Reducing heat load density with asymmetric and inclined double-crystal monochromators: principles and requirements revisited. [PDF]

J Synchrotron Radiat
Huang X, Assoufid L, Macrander AT.
europepmc   +1 more source

Slip Localization Intensification Mediated by Grain Boundary Sliding in a Polycrystalline Nickel‐Based Superalloy

Advanced Engineering Materials, EarlyView.
The temperature dependence of fatigue behavior in nickel‐based superalloys is investigated through high‐resolution measurements of plastic localization. While increasing temperature reduces localization and enhances fatigue performance in René 88DT, Inconel 718 exhibits a sharp degradation at intermediate temperature due to intensified slip ...
M. Calvat, D. Anjaria, I. Woo, C. Bean, D. Texier, J. C. Stinville   +5 more
wiley   +1 more source

Allostasis as a consequence of high heat load in grain-fed feedlot cattle. [PDF]

Transl Anim Sci
Wijffels G, Lees AM, Sullivan ML, Sammes SL, Li Y, Gaughan JB.   +5 more
europepmc   +1 more source

Investigation of a Novel Air Source Heat Pump Test Platform [PDF]

A flexible air source heat pump testing platform is being developed at the National Renewable Energy Centre that will have the advantages of both a field trial and a laboratory test.
Shi, Yuan
core  

Creep‐Induced Microstructural Evolution in an A2‐B2 Superalloy

Advanced Engineering Materials, EarlyView.
A 27.3Ta‐27.3Mo‐27.3Ti‐8Cr‐10Al (at.%) refractory high‐entropy alloy with precipitation‐strengthened A2‐B2 microstructure was studied by creep tests at 1030°C, which demonstrate a transition in deformation mechanisms in the range of 100–150 MPa applied stress. This is associated with changes in dislocation–precipitate interactions. Relevant deformation
Liu Yang, Aparajita Pramanik, Sandipan Sen, Shubhashis Dixit, Marcel Muench, R. J. Vikram, Daniel Schliephake, Yolita M. Eggeler, Ankur Chauhan, Martin Heilmaier, Alexander Kauffmann   +10 more
wiley   +1 more source

CFD modeling of thermal processes in the firebox and heat load distribution on the screen surface firebox. [PDF]

Heliyon
Lohvyniuk M, Novakivskyi Y.
europepmc   +1 more source

Influence of Test Temperature and Test Frequency on Fatigue Life of Aluminum Alloy EN AW‐2618A

Advanced Engineering Materials, EarlyView.
The influence of test temperature and test frequency on the fatigue life of EN AW‐2618A is investigated. High‐cycle fatigue tests are performed at different test temperatures and frequencies on the 1000 h/230°C overaged state. Both test parameters reduce fatigue life due to time‐dependent damage mechanisms.
Ying Han, Julian M. Rosalie, Jan Radners, Mauro Madia, Philipp von Hartrott, Birgit Skrotzki   +5 more
wiley   +1 more source

Seasonal activity patterns of a Kalahari mammal community: Trade-offs between environmental heat load and predation pressure. [PDF]

Ecol Evol
Vermeulen MM, Fritz H, Strauss WM, Hetem RS, Venter JA.   +4 more
europepmc   +1 more source

Assessment of downhole heat exchangers in Puna district, Hawaii

, 2007
"Downhole heat exchangers (DHEs) have the potential for use in direct (non-electric) applications of geothermal energy. Their benefit is that no groundwater is extracted from wells.
Geo-Heat Center, Oregon Institute of Technology
core  

High‐Temperature Nanoindentation of Metals: Assessing Thermal Drift, Frame Compliance, and Chemical Composition Effects on the Reported Mechanical Properties

Advanced Engineering Materials, EarlyView.
Do not let thermal drift and instrument artifacts deceive high‐temperature nanoindentation results. We compare classical Oliver–Pharr and automatic image recognition analyses across steels and a Ni alloy to quantify these effects. Accounting for artifacts reveals systematic softening with temperature, while Cr and Ni additions boost resistance ...
Velislava Yonkova, Steffen Brinckmann, Ruth Schwaiger   +2 more
wiley   +1 more source