Results 101 to 110 of about 955,344 (308)
Comparison of four layouts of optimized triple-pressure heat recovery steam generator
Case Studies in Thermal EngineeringTriple-pressure heat recovery steam generators are found in various sizes of combined cycle power plants. A triple-pressure heat recovery steam generator consists of economizers, evaporators, and superheaters at high, intermediate, and low pressures ...
Somchart Chantasiriwan
doaj +1 more source
Energy Engineering, 2009 Investments in waste heat recovery provide a very attractive payback. This article covers cases implemented over the past four years among Shaw's 50 manufacturing plants. Heat sources tapped are air compressors, waste water, boiler stack gasses, and boiler blow down. The destination for the heat is process water heating and boiler make-up water heating.
openaire +1 more source
Zein‐Based Adhesives: Sustainable Extraction and Application in Bioadhesive Technologies
Advanced Engineering Materials, EarlyView.Zein is extracted from corn gluten meal using a simple and scalable process with high yield (~90%). The resulting protein is applied in bioadhesives modified with Ca2+ and Fe3+ ions, exhibiting substrate‐dependent adhesion. The findings demonstrate competitive bonding performance and highlight the role of ionic interactions in tuning adhesion ...
Paula Bertolino Sanvezzo +3 more
wiley +1 more source
Study of fuel cell powerplant with heat recovery [PDF]
It was shown that heat can be recovered from fuel cell power plants by replacing the air-cooled heat exchangers in present designs with units which transfer the heat to the integrated utility system.
Clausi, J. V. +2 more
core +1 more source
Technique for highly efficient recovery of microbiological contaminants [PDF]
, 1969 Collecting and recovery small assay samples of viable microbiological contaminants in a gas stream involves use of a commercially available water-soluble paper.
Godwin, W. W.
core +1 more source
Advanced Engineering Materials, EarlyView.Low‐cycle fatigue damage in Mn–Mo–Ni reactor pressure vessel steel is examined using a combined electron backscatter diffraction and positron annihilation lifetime spectroscopy approach. The study correlates texture evolution, dislocation substructure development, and vacancy‐type defect formation across uniform, necked, and fracture regions, providing
Apu Sarkar +2 more
wiley +1 more source
High-performance heat pipes for heat recovery applications [PDF]
Methods to improve the performance of reflux heat pipes for heat recovery applications were examined both analytically and experimentally. Various models for the estimation of reflux heat pipe transport capacity were surveyed in the literature and ...
Hartl, J. H., Saaski, E. W.
core +1 more source
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
Chemical and Process Engineering, 2016 This paper presents studies carried out in a pilot-scale plant for recovery of waste heat from a flue gas which has been built in a lignite-fired power plant.
Szulc Piotr +2 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Trace additions of Sn and Sr combined with a two‐step aging treatment are shown to enhance the microstructure and performance of Al–Zr–Sc conductor alloys. Strength and electrical conductivity increase concurrently through accelerated precipitation of fine Al3(Sc, Zr) precipitates and improved dislocation resistance, offering a cost‐effective pathway ...
Quan Shao +3 more
wiley +1 more source