Results 111 to 120 of about 11,792 (267)

A Methodology to Integrate Closed‐Cycle Heat Pumps into Batch Distillation Columns

Chemie Ingenieur Technik, EarlyView.
Batch distillation often cannot use vapor recompression due to contamination risks in food and pharma. This study proposes a design for integrating closed‐loop heat pumps using natural fluids. Results show significant energy savings, offering a sustainable alternative to traditional setups.
Philipp Dorn, Michael Libuda, Thomas Meyer, Christian Hoffmann, Jens‐Uwe Repke, Stefan Elbel   +5 more
wiley   +1 more source

In Situ Methanation on Mars: A Process Concept Study on the Impact of H2/CO2 and Recycle Ratio

Chemie Ingenieur Technik, EarlyView.
The rocket propellant methane can be produced on Mars by in situ resource utilization. The H2/CO2 ratio is decisive, and excess H2 is favored for providing sufficient propellant purity. The operation mode—with or without recycling of unreacted reactants—depends on the resource availability of the selected landing site. Abstract For return missions from
Franz Braun, Thomas‐Oliver Nagel, Samuel Prinz, Jens Friedland, Robert Güttel   +4 more
wiley   +1 more source

3D‐Printed Coil Immobilized Enzyme Reactors for Laccase Biocatalysis in Single‐ and Two‐Phase Flow

Chemie Ingenieur Technik, EarlyView.
Development of 3D‐printed immobilized enzyme reactors functionalized with laccase for continuous‐flow biocatalysis. Surface coupling and reactor design enhanced stability and mass transfer, enabling efficient and reusable biocatalytic processes.
Alina J. Tauriainen, Alexander S. Sommer‐Behr, Julian Handke, Stephan Lütz, Norbert Kockmann   +4 more
wiley   +1 more source

Potential Analysis of On‐Site Oxygen and Ozone Production for Wastewater Treatment Plants

Chemie Ingenieur Technik, EarlyView.
The potential of a power‐to‐gas process focusing on the oxygen stream to cover an upcoming demand of ozone at German wastewater treatment plants is analyzed. Economic and ecological parameters are compared to the conventional production of hydrogen and oxygen. Powered by on‐site produced wind energy, the process is deemed beneficial.
Vincenta Franßen, Paul Goerdten, Christian Hoffmann, Jens‐Uwe Repke   +3 more
wiley   +1 more source

Air Conditioner with Latent Heat Storage Tank

Journal of the Society of Mechanical Engineers, 2013
Hideki TAKEBAYASHI, Naomichi YANO
openaire   +2 more sources

Hydroprocessing of synthetic kerosene over a non‐sulphided Ni/Al2O3 catalyst: Impact of alcohols and ketones on alkene conversion

The Canadian Journal of Chemical Engineering, EarlyView.
Abstract Synthetic jet fuel containing non‐petroleum‐derived kerosene can be produced from synthetic kerosene obtained through processes that include a hydroprocessing step. The potential use of non‐sulphided (reduced) nickel supported on alumina (Ni/Al2O3) was evaluated as an alternative to sulphided catalysts to saturate alkenes in sulphur‐free ...
Garima Chauhan, Felix Link, Cibele Melo Halmenschlager, Arno de Klerk   +3 more
wiley   +1 more source

Waste activated sludge high‐rate treatment of septage: Biodegradability studies and contact phase trials towards a cleaner environment

The Canadian Journal of Chemical Engineering, EarlyView.
Abstract The waste activated sludge high‐rate (WASHR) process, developed in our previous study, is used for septic wastewater treatment. This high‐rate contact stabilization pre‐treatment uses typical waste streams found in wastewater treatment plants to reduce a portion of the loadings on the main treatment trains.
Arman Shirali, Melody Blythe Johnson, Mehrab Mehrvar   +2 more
wiley   +1 more source

Application of influence diagrams to multi‐objective allocation of firefighting resources in process plants

The Canadian Journal of Chemical Engineering, EarlyView.
Abstract Identification of firefighting strategies (i.e., which endangered units to suppress or cool first) in chemical and process plants falls under the domain of multi‐objective decision‐making (MODM), where not only the safety and integrity of the affected process plant but also the safety of on‐site and off‐site vulnerable targets matter.
Sina Khakzad, Nima Khakzad
wiley   +1 more source

Modelling of continuous low‐temperature emulsion co‐polymerization in 3D‐printed reactor

The Canadian Journal of Chemical Engineering, EarlyView.
A kinetic model for the emulsion copolymerization of butyl acrylate/styrene at low temperatures is proposed and validated against experiments with a redox initiator system. The model was successfully transferred to a 3D‐printed tubular reactor and conversions of more than 80% and small particles sizes below 40 nm were observed.
Ferel Issa, Andreas Reinbeck, Kristina M. Zentel   +2 more
wiley   +1 more source

Practice and Optimization of Seasonal/Daily Composite Thermal Energy Storage Technology Based on Lakes/Rivers

Zhileng xuebao
In the context of low/zero-carbon heating, heat pump technology has emerged as the inevitable path in the field of medium and low-temperature heating due to their high efficiency in electrical-to-thermal energy conversion.
YANG Shuchuan, YIN Yonggao, LI Xiao, ZHAO Donglin, CUI Mengying   +4 more
doaj