Results 131 to 140 of about 122,106 (314)
Cathodic Cage Plasma Deposition of Nanostructured Cu–Fe–Se Coatings on Poly(methyl Methacrylate)
Advanced Engineering Materials, EarlyView.Nanostructured Cu–Fe–Se coatings are deposited on PMMA by a modified cathodic cage plasma process, enabling low‐temperature deposition on polymer substrates. A transition from discontinuous to compact morphology is observed with temperature, with optimal properties at 200°C, where improved CuFeSe2‐type bonding, lowest sheet resistance, and favorable ...
V. S. S. Sobrinho +8 more
wiley +1 more source
Transition boiling heat transfer from a horizontal surface
, 1960 An experiment, utilising a condensing fluid as the heat source, was performed to determine the heat flux vs. temperature difference curve for transition pool boiling from a horisontal surface.
Berenson Paul Jerome
core
Determination of Heat Transfer Coefficient for Air-Atomized Water Spray Cooling and Its Application in Modeling of Thermomechanical Controlled Processing of Die Forgings. [PDF]
Materials (Basel), 2022 Apostoł M, Skubisz P, Adrian H.
europepmc +1 more source
Nondestructive Testing of Welded Composite Metal Foams
Advanced Engineering Materials, EarlyView.X‐ray computed tomography (CT) is used to evaluate welded steel–steel composite metal foam (CMF) joints of two density classes. It reports variation in postweld spatial void distribution and correlates it to weld‐induced changes, mechanical performance, and failure within welded CMF panels.
Chinmaya Prerana Inguva +2 more
wiley +1 more source
low Boiling Heat Transfer Characteristics of R290 in 5mm Small-diameter Tubes
Zhileng xuebao, 2019 The characteristics of heat transfer for R290 flow boiling in 5 mm small diameter tubes were investigated experimentally with a focus on the effects of heat flux, mass flow rate, and saturation temperature on the surface coefficient of boiling heat ...
He Kuan, Liu Jianhua, Yu Xiaoxiao
doaj
Effect of the Aspect Ratio and Tilt Angle on the Free Convection Heat Transfer Coefficient Inside Al2O3-Water-Filled Square Cuboid Enclosures. [PDF]
Nanomaterials (Basel), 2022 Almuzaiqer R, Ali ME, Al-Salem K.
europepmc +1 more source
Advanced Engineering Materials, EarlyView.Aluminum and nitride coatings are used in industry because they are hard, resist wear, and protect against oxidation. Adding boron can improve friction behavior and other properties. This study tests coatings on surfaces with different finishes. Results show smoother surfaces perform better, while rough ones wear faster, although coatings can reduce ...
Adrián Claver +9 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Low‐voltage FIB‐SEM tomography combined with a image preprocessing pipeline improves phase contrast and enables reliable machine‐learning segmentation of conductive networks in lithium‐ion battery electrodes. Structural descriptors are extracted from segmented images, done semimanually and automated, and compared.
Lisa Beran +6 more
wiley +1 more source
Zhileng xuebaoIn this study, the flow boiling heat transfer and pressure drop of R245fa in a dimpled flat tube were experimentally measured. The effects of vapor quality and heat flux were analyzed accordingly.
Feng Ye, Ding Puxian, Shao Shuangquan
doaj
Heat transfer coefficients for slab shaped products subjected to heating
International Communications in Heat and Mass Transfer, 1994 Abstract An analytical model was obtained to determine heat transfer coefficients for slab shaped food products heated in a convection oven. The variation of the center temperature of the products was measured and converted into dimensionless form.
openaire +2 more sources