Results 181 to 190 of about 4,323,986 (291)

Sub‐1 ms Optoelectronic Synapse Based on {ZnCdO/ZnO} Multilayer Structure for High‐Speed Neuromorphic Vision Systems

open access: yesAdvanced Functional Materials, EarlyView.
Eu‐doped {ZnCdO/ZnO} structures grown on Si are developed, showcasing dual‐functionality controlled by europium doping. While high europium concentration transforms the device into an ultrafast, self‐powered photodetector, low‐doped structures can be used as an optoelectronic synapse.
Igor Perlikowski   +3 more
wiley   +1 more source

Amphoteric Cu‐Doping Leading to High Thermoelectric Performance in p‐Type Bismuth Antimony Telluride

open access: yesAdvanced Functional Materials, EarlyView.
This study shows that Cu plays two opposite roles in p‐type Bi0.5Sb1.5Te3 depending on the processing route. Under thermodynamic‐equilibrium bulk‐synthesis, Cu mainly occupies cation sites, increases hole concentration, preserves mobility, and slightly reduces lattice heat transport. The best‐performing composition among the investigated series reaches
Moritz Thiem   +15 more
wiley   +1 more source

Sacrificial‐Layer‐Assisted Heat‐Affected‐Zone Suppression in Laser Patterning of PET for High‐Performance Flexible Devices

open access: yesAdvanced Functional Materials, EarlyView.
A removable sacrificial polymer layer engineers the thermal boundary condition during nanosecond laser ablation of PET, suppressing heat‐affected‐zone formation without relying on costly ultrafast lasers. This strategy enables deep, high‐aspect‐ratio trenches with no detectable heat‐affected zone, templating silver‐filled mesh electrodes with record ...
Mehdi Zarei   +3 more
wiley   +1 more source

Experimental analysis of heat transfer coefficient in the plate heat exchanger

open access: yes, 2011
In this study, heat transfer coefficient of plate heat exchanger was experimentally investigated. Plate heat exchanger into experimental mechanism was set. Different tests by varying of mass flow rates and inlet temperatures were carried out. Analyses of obtained results were performed. Variation of heat transfer coefficient of plate heat exchanger was
openaire   +2 more sources

Nano Borophene as a Programmable 2D Scaffold for Organized DNA Assembly and Long‐Range Energy Transfer

open access: yesAdvanced Functional Materials, EarlyView.
Borophene is introduced as a programmable 2D bio‐interface that organizes DNA through dual boron–sulfur and nucleobase interactions. This molecular architecture enables efficient long‐range nanosurface energy transfer, establishing new design principles for functional nano–bio interfaces and amplification‐free optical biosensing.
Teresa Aditya   +11 more
wiley   +1 more source

Nitride MXenes Beyond Carbides: Bridging the Gap Between Computational Prediction and Experimental Realization

open access: yesAdvanced Functional Materials, EarlyView.
Nitride MXenes remain constrained by a persistent gap between computational prediction and experimental realization. This Review identifies the thermodynamic, kinetic, and chemical barriers limiting their synthesis, critically evaluates emerging fabrication routes, and proposes a multidimensional computational‐experimental framework to accelerate the ...
Naresh Varnakavi, Masoud Soroush
wiley   +1 more source

Heat Transfer Enhancement in a Shell-and-Tube Type of Heat Exchanger Using Al<sub>2</sub>O<sub>3</sub>/Water Nanofluid. [PDF]

open access: yesACS Omega
Pacherres Uchalin MAT   +6 more
europepmc   +1 more source

Lewis Acid Site Engineering in MOF‐Derived Aluminum Oxide/Carbon Composites for Dechlorination of Waste Plastic Pyrolysis Oil

open access: yesAdvanced Functional Materials, EarlyView.
Controlled carbonization of an Al‐MOF partially decomposes its linkers, exposing coordinatively unsaturated Al centers within an oxide/carbon composite. The resulting Lewis acid sites, rather than surface area, govern organochlorine capture: the composite removes chemically diverse organochlorines from waste plastic pyrolysis oil, outperforms a ...
Seong Cheon Kim   +6 more
wiley   +1 more source

Additively Manufactured Geometry‐Reconfigurable Soft Neural Probes With Monolithic Multifunctionality

open access: yesAdvanced Functional Materials, EarlyView.
A geometry‐reconfigured additive manufacturing strategy converts planar printed soft materials into soft compact neural probes with integrated hydrogel electrodes and microfluidic channels. The resulting NeuroMAP platform enables scalable multichannel recording, localized chemical delivery, stable in vivo electrophysiological recording, and reduced ...
Hyunjin Lee   +15 more
wiley   +1 more source

Home - About - Disclaimer - Privacy