Results 121 to 130 of about 6,033,541 (342)
A Heat Transfer Model Combining Differential and Integral Formulations for Thermal Analysis of Reciprocating Compressors [PDF]
Heat transfer in hermetic compressors is a complex phenomenon strongly affected by fluid flow inside and outside the compression chamber and by the efficiency of both the electrical motor and the crankshaft mechanism.
Deschamps, Cesar J., Sanvezzo Jr, Joel
core
To enhance through‐thickness conductivity without sacrificing impregnation, large spherical graphite particles are intentionally employed in a low‐viscosity resin. Unlike finer conductive fillers, these particles remain outside the fiber bundles and accumulate in resin‐rich interlaminar regions during molding.
Keito Hosoe +6 more
wiley +1 more source
Rotary 3D Printing With Integrated Electroplating
A rotary material extrusion platform integrates localized copper electroplating with printing and encapsulation to fabricate cylindrical polymer–metal structures containing fully embedded, low‐resistance conductive pathways that enable internal Joule heating and thermally activated shape‐memory responses.
Antonio Zagaria +5 more
wiley +1 more source
Microstructural evolution of premium rail steel during flash butt welding (FBW), comparing physically simulated heat‐affected zones with actual weld regions. Thermal cycles induce phase transformations and microstructural heterogeneity that influence weld quality and mechanical performance. These findings provide insights into optimizing FBW parameters
Emmanoelle Cintra da Cunha Araújo +15 more
wiley +1 more source
Boiling and condensation in a liquid-filled enclosure [PDF]
A combined experimental and analytical investigation of boiling and condensation in a liquid-filled enclosure, with water and Freon- 113 as the working fluids, is described.
Bergles A. E., Bar-Cohen Avram
core
A thermoplastic PMMA‐based photoresin enables high‐resolution DLP printing followed by solvent‐vapor smoothing. The treatment reduces staircase‐induced surface roughness from 2.33 µm to 129 nm and increases visible‐light transmittance from approximately 30% to 80%, providing a route toward transparent PMMA components for rapid prototyping and non ...
Rozhin Heydarpour +5 more
wiley +1 more source
The ALD precursor bis(trimethylsilyl)selenide is simultaneously a substrate surface inhibitor. It allows for the growth of Sb2Se3 in combination with tris(dimethylamido)antimony, but also silylates surface hydroxyl groups on the substrate if such hydroxyls are present.
Pei‐Chun Liao +9 more
wiley +1 more source
THERMO FLUID DYNAMIC EULER-LAGRANGE CFD ANALYSIS APPLIED TO WET FLUE GAS DESULPHURISATION TECHNOLOGY [PDF]
Paper presented at the 6th International Conference on Heat Transfer, Fluid Mechanics and Thermodynamics, South Africa, 30 June - 2 July, 2008.Wet Flue Gas Desulphurisation (FGD) technology is the most frequently used scrubbing process for sulphur ...
Inzoli, F. +5 more
core
Edible Cuttlefish Ink: Complex Chemistry, Structure, and Electrical Response
An integrated approach of chemistry‐structure‐electrical properties is used to assess the potential of edible cuttlefish ink as a bio‐based conductive ink for printable electronics. Chromatography and Neutron Activation Analysis reveal a fascinating molecular and elemental diversity.
Camille Bour‐Cardinal +5 more
wiley +1 more source
Parallel Triangular Channel System for Latent Heat Thermal Energy Storages
A computational investigation on thermal energy storage system using Phase Change Material (PCM) is accomplished. The system is a honeycomb structure made of parallel triangular channels and half of them are filled with PCM and the others are passed ...
A. ANDREOZZI +7 more
core +1 more source

