Results 181 to 190 of about 418,548 (318)

Electrochemical Evaluation of Compressed Selective Laser Melted AlSi7Mg and AlSi10Mg Alloys in Chloride Environment

Advanced Engineering Materials, EarlyView.
The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin, Samson Dare Oguntuyi, Peter Apata Olubambi   +2 more
wiley   +1 more source

A Numerical Study of Convective Heat Transfer in the Compression Chambers of Scroll Compressors

, 2012
Convective heat transfer in the compression chambers of scroll compressors affects important quantities associated with the compression cycle, such as the volumetric efficiency and the discharge gas temperature.
Deschamps, Cesar J., Pereira, Evandro L. L.   +1 more
core   +1 more source

Extreme longitudinal thermal conductivity and non-diffusive heat transport in isotopic hBN. [PDF]

Nat Commun
Brochard-Richard C, Di Berardino G, Herth E, Wei C, Panciera F, Poirier T, Edgar JH, Gil B, Cassabois G, Della Rocca ML, Sarkar S, Bendiab N, Marty L, Oehler F, Ouerghi A, Chaste J.   +15 more
europepmc   +1 more source

Engineering Heat Transport Across Epitaxial Lattice-Mismatched van der Waals Heterointerfaces. [PDF]

Nano Lett, 2023
Chavez-Angel E, Tsipas P, Xiao P, Ahmadi MT, Daaoub AHS, Sadeghi H, Sotomayor Torres CM, Dimoulas A, Sachat AE.   +8 more
europepmc   +1 more source

Characterization of Aluminized Layers on Inconel‐738 Alloy: Microstructure, Modeling of Aluminizing Kinetics, and Thermal Behavior

Advanced Engineering Materials, EarlyView.
This study explored how effective nickel aluminide coatings are obtained in providing oxidation resistance applied to the Inconel 738 alloy, modeling with diffusion models. In the present study, kinetics and thermal behavior of the Inconel 738 alloy were studied by the low‐temperature thermoreactive aluminizing process, which was carried out at 625°C ...
Gozde Celebi Efe, Tuba Yener, Suayb Cagri Yener, Mourad Keddam, Cuma Bindal   +4 more
wiley   +1 more source

Thermal metamaterials for enhanced non-Fourier heat transport. [PDF]

NPJ Metamater
Mclean H, Davies FH, Taylor NT, Hepplestone SP.   +3 more
europepmc   +1 more source

Heat transport in inclined flow towards a rotating disk under MHD. [PDF]

Sci Rep, 2023
Mahmud K, Duraihem FZ, Mehmood R, Sarkar S, Saleem S, Saleem S.   +5 more
europepmc   +1 more source

Innovative Processing of Compacted Waste Aluminum Alloy Powders via Controlled Remelting and Solidification

Advanced Engineering Materials, EarlyView.
This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira, Marcella Gaute Cavalcante Xavier, Abdoul‐Aziz Bogno, Piter Gargarella, José Eduardo Spinelli   +4 more
wiley   +1 more source

Experimental Results of a Newly Developed Very High Temperature Industrial Heat Pump (140°C) Equipped With Scroll Compressors and Working With a New Blend Refrigerant

, 2012
During last decades more and more attention has been paid on CO2 emissions. One of the solutions for decreasing CO2 emissions concerns the substitution of fossil fuels industrial boilers by the use of very high temperature electrical heat pumps. Moreover,
Bourig, Ali, Bobelin, Damien
core   +1 more source

The Knudsen Layer in the Heat Transport Beyond the Fourier Law: Application to the Wave Propagation at Nanoscale. [PDF]

Entropy (Basel)
Carlomagno I, Sellitto A.
europepmc   +1 more source