Scientific Reports, 2021 The plastic deformation behavior of single crystals of two transition-metal diborides, ZrB2 and TiB2 with the AlB2 structure has been investigated at room temperature as a function of crystal orientation and specimen size by micropillar compression tests.
Zhenghao Chen +6 more
doaj +1 more source
The effects of carboxylic acids in aluminum anodizing [PDF]
, 2017 Hard-anodized alumina coatings were formed in sulfuric acid at low temperature and high current density in the presence of carboxylic acid additives. Citric acid, trimesic acid, mellitic acid and ethylenediaminetetraacetic acid (EDTA) were utilized in ...
Koczera, Abby E
core +1 more source
Accelerating corrosion in a laboratory set-up for corrosion-fatigue of offshore steels [PDF]
, 2016 Corrosion-fatigue is a dangerous failure mechanism that is not yet fully understood. Structures subjected to corrosion-fatigue are over conservative in design, which is economically unfavourable.
De Waele, Wim +3 more
core +1 more source
The significance of velocity exponents in identifying erosion-corrosion mechanisms [PDF]
, 1993 The modes of erosion-corrosion are diverse and may vary from being ''erosion-dominated'', where erosion of metal is the dominant process, to ''corrosion-dominated'', where erosion of oxide scale is the dominant process.
Stack, Margaret, Stott, F.H., Wood, G.C.
core +3 more sources
Predicting the steady state thickness of passive films in order to prevent degradations of implant [PDF]
, 2013 Some implants have approximately a lifetime of 15 years. The femoral stem, for example, should be made of 316L/316LN stainless steel. Fretting corrosion, friction under small displacements, should occur during human gait, due to repeated loadings and un ...
Geringer, Jean +2 more
core +2 more sources
Investigation into high-temperature corrosion in a large-scale municipal waste-to-energy plant
, 2010 High-temperature corrosion in the superheater of a large-scale waste-to-energy plant was investigated. A comparison of nickel-/iron-based alloys and austenitic stainless steel probes placed in the furnace demonstrated that temperature and particle ...
Finney, K.N. +6 more
core +1 more source
Structural analysis and corrosion studies on an ISO 5832-9 biomedical alloy with TiO2 sol–gel layers [PDF]
, 2013 The aim of this study was to demonstrate the relationship between the structural and corrosion properties of an ISO 5832-9 biomedical alloy modified with titanium dioxide (TiO2) layers.
A Balamurugan +49 more
core +3 more sources
Corrosion Damages Induced by Cyclic Exposure of 2024 Aluminum Alloy in Chloride-Containing Environments [PDF]
, 2011 This paper focuses on the influence of cyclic exposure to chloride solutions on corrosion damage morphology developed on AA2024. The influence of the temperature during the air exposure periods was studied.
Alexis, Joël +5 more
core +2 more sources
Corrosion and corrosion prevention in gas turbines [PDF]
The conditions governing the corrosion behavior in gas turbines are surveyed. Factors such as temperature, relative humidity, the presence of sulfur and nitrogen dioxide, and fuel quality are discussed.
Kolkman, H. J., Mom, A. J. A.
core +1 more source
Combined Kelvin probe force microscopy and secondary ion mass spectrometry for hydrogen detection in corroded 2024 aluminium alloy [PDF]
, 2013 The capability of Kelvin probe force microscopy (KFM) to detect and locate hydrogen in corroded 2024 aluminium alloy was demonstrated. Hydrogen was introduced inside the 2024 alloy following a cyclic corrosion test consisting of cycles of immersion in 1 ...
Alexis, Joël +5 more
core +3 more sources