Results 101 to 110 of about 249,891 (224)
Duplex Stainless Steel Laser‐Surface Textured: Stability in Brine Solution
Advanced Engineering Materials, EarlyView.Controlled laser‐surface treatment (LST) of duplex DSS2205 steel is performed to increase its stability in brine solution under cyclic electrochemical assays. The superior protection with respect to flat and smooth panels is attributed to the presence of FeCr2O4 as the main protective oxide layer in the LST surface, after corrosion tests. The stability
Mohammad Rezayat +5 more
wiley +1 more source
Wavelet-based EMTR method for fault location of VSC-HVDC transmission lines
The Journal of Engineering, 2018 A wavelet-based electromagnetic time reversal method for locating faults in voltage source converter-high-voltage direct current (VSC-HVDC) transmission lines is proposed in this study.
Xipeng Zhang +4 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Herein, environmental scanning electron microscopy (ESEM) is discussed as a powerful extension of conventional SEM for life sciences. By combining high‐resolution imaging with variable pressure and humidity, ESEM allows the analysis of untreated biological materials, supports in situ monitoring of hydration‐driven changes, and advances the functional ...
Jendrian Riedel +6 more
wiley +1 more source
High Frequency Quantum Admittance and Noise Measurement with an On-chip Resonant Circuit
, 2012 By coupling a quantum detector, a superconductor-insulator-superconductor junction, to a Josephson junction \textit{via} a resonant circuit we probe the high frequency properties, namely the ac complex admittance and the current fluctuations of the ...
A. Barone +7 more
core +1 more source
Advanced Engineering Materials, EarlyView.It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti +11 more
wiley +1 more source
Study the performance of High Voltage Direct Current Transmission using MATLAB
مجلة النهرين للعلوم الهندسية, 2008 Some of the electric networks adjacent countries are linked to either the alternating current lines or to direct current lines, that is really depends upon the eographic distance of the linking points and the amount of the used current. In view of rapid
Jameel K. Abed Al-Jashami
doaj
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
Quantum Transport Characteristics of Lateral pn-Junction of Single Layer TiS3
, 2016 Using density functional theory and nonequilibrium Greens functions-based methods we investigated the electronic and transport properties of monolayer TiS3 pn-junction. We constructed a lateral pn-junction in monolayer TiS3 by using Li and F adatoms.
Iyikanat, F. +3 more
core +1 more source
Advanced Engineering Materials, EarlyView.Creep experiments at 900°C on coarse‐grained steel‐ceramic composites containing recycled magnesia reveal that higher ceramic volume fractions significantly enhance the creep resistance. Detailed EBSD investigations identify subgrain formation in the steel matrix as the dominant deformation mechanism.
Moritz Müller +6 more
wiley +1 more source
Netzsituation in Deutschland bleibt stabil [PDF]
, 2013 Auch im zweiten Jahr nach dem Kernkraftwerksmoratorium vom März 2011 bleibt die Lage im deutschen Stromübertragungsnetz stabil. Auch wenn die Realisierung einiger Ausbauprojekte um einige Jahre hinter dem ursprünglichen Zeitplan liegt, schreitet der ...
Gerbaulet, Clemens +3 more
core