Results 11 to 20 of about 19,505,513 (243)
Frequency and phase modulation performance of an injection-locked CW magnetron. [PDF]
It is demonstrated that the output of a 2.45-GHz magnetron operated as a current-controlled oscillator through its pushing characteristic can lock to injection signals in times of the order of 100-500 ns depending on injection power, magnetron heater ...
Carter, Richard G. +2 more
core +6 more sources
CARRIER SIGNAL INJECTION BASED SENSORLESS CONTROL OF PERMANENT MAGNET BRUSHLESS AC MACHINES [PDF]
This thesis is focused on the carrier signal injection based sensorless control of Permanent Magnet (PM) Brushless AC (BLAC) machines. Based on the machine saliency property, carrier signal injection based sensorless techniques have been well developed ...
Gong, Liming
core +6 more sources
Sensorless position control of permanent magnet motors with pulsating current injection and compensation of motor end-effects [PDF]
The sensorless position control of permanent-magnet motors is successfully implemented by superimposing a high-frequency voltage signal on the voltage reference or adding a high-frequency current signal to the current reference.
G Pellegrino +14 more
core +1 more source
The new topology of the dual-armature flux-switching permanent magnet machine (DA-FSPM) leads to new characteristics and issues in the control of the machine, of which the mutual inductance of the two sets of armature windings is the most important one ...
Lijian Wu +4 more
doaj +1 more source
We demonstrate the use of a self-injection locked distributed feedback (DFB) diode laser for high-sensitivity detection of acoustic emission (AE) using a fiber-coil Fabry-Perot interferometer (FPI) sensor.
Farzia Karim +3 more
doaj +1 more source
It is difficult to decompose the in-cylinder pressure of combustion of the direct injection (DI) diesel engine, a transient process associated with complicated oscillation components, because of its steep property. An adaptive cyclic average method based
Xu Zheng +5 more
doaj +1 more source
Single-Phase Fault Line Selection in Distribution Network Based on Signal Injection Method
The distribution network with small current grounding mode can ensure high power supply reliability, but it is difficult to locate single-phase grounding fault line. Most of the faults in distribution network are single-phase to ground fault.
Lin Niu, Guiqing Wu, Zhangsheng Xu
doaj +1 more source
Long wavelength VCSEL-by-VCSEL optical injection-Locking [PDF]
VCSEL-by-VCSEL optical injection-locking to obtain high cut-off frequencies of 1.3 μm Vertical-Cavity Surface-Emitting Lasers (VCSELs) is demonstrated. A detailed physical explanation of the underlying mechanism is presented.
Sirbu, A. +20 more
core +1 more source
Diesel Engine Injector Faults Detection Using Acoustic Emissions Technique [PDF]
This study focuses on investigation of the method of identifying injector faults in a JCB 444T2 diesel engine using acoustic emission (AE) technique. Different kinds of injector faults were seeded in the four-cylinder, four-stroke, and turbo-engine. Then,
Gu, Fengshou +2 more
core +3 more sources
Virtual Signal Injection Maximum Torque per Ampere Control Based on Inductor Identification
The high-frequency signal injection-type maximum torque per ampere (MTPA) algorithm is usually employed to control the operation of interior permanent magnet synchronous motors (IPMSMs).
Ning-Zhi Jin +5 more
doaj +1 more source

