Results 141 to 150 of about 28,279 (257)

Structural Colors from Modulated Topological Defects in Molecular Smectic Liquid Crystals

open access: yesAdvanced Science, EarlyView.
Rather than using dyes and pigments, nature produces the colors of some butterflies and beetles through optical interference phenomena. This study describes an original biomimetic strategy exploiting the spontaneous formation of modulated linear defects in thin films of 8CB, a common molecular liquid crystal.
Camille N. Mahyaoui   +7 more
wiley   +1 more source

Leading the Pack: Next‐Generation Batteries for Humanoid Robotics

open access: yesAdvanced Science, EarlyView.
Humanoid robots challenge traditional and anticipated energy technologies. Humanoid robot benchmarks of runtimes and energy demands for industry applications inform humanoid robot battery design choices at the cell level, pack level, and system level.
Matthew Bergschneider   +6 more
wiley   +1 more source

Scalable MoS2/Si Photodiode Arrays From Roll‐to‐Roll Mechanical Exfoliation

open access: yesAdvanced Science, EarlyView.
A dry roll‐to‐roll route transforms mechanically exfoliated MoS2 flake networks into silicon‐integrated photodiode arrays. The MoS2/Si junctions generate photovoltaic output without applied bias, allowing illuminated pixels to locate light spots and reconstruct simple images.
Yigit Sozen   +2 more
wiley   +1 more source

Single‐Atom‐Enhanced Fully Inkjet‐Printed Electrochemical Sensor for Dopamine Detection

open access: yesAdvanced Science, EarlyView.
Fully inkjet‐printed paper‐based dopamine sensors are fabricated using nitrogen‐doped graphene acid functionalized with copper single atoms. The copper sites uniquely enhance dopamine oxidation through strong molecular adsorption, as verified by electrochemical measurements and DFT calculations. The approach highlights the potential of single‐atom inks
Martin‐Alex Nalepa   +11 more
wiley   +1 more source

Measurement of Water Jet Properties of High Pressure Water Atomization.

open access: yesJournal of the Japan Society of Powder and Powder Metallurgy, 1993
Minagawa, Kazumi   +2 more
openaire   +2 more sources

Bending‐Stable Pressure Sensor Based on Natural Wood Nanofibers for Ultra‐Low Detection Limit

open access: yesAdvanced Science, EarlyView.
A wood nanofiber‐based flexible pressure sensor with intrinsic bending‐stable performance is developed through a porous electrospun architecture and interdigital electrode design. The device exhibits an ultra‐low detection limit and stable operation under deformation for physiological monitoring and spatial sensing, providing a sustainable strategy for
Xu Zeng   +7 more
wiley   +1 more source

Nanoparticle‐Mediated Bubble Suppression During Droplet Solidification for Mechanical Reinforcement

open access: yesAdvanced Science, EarlyView.
Nanoparticles mediate droplet solidification by raising nucleation temperature, refining dendrites, and slowing freezing‐front advance, thereby suppressing trapped air bubbles in droplet‐based 3D printing. This strategy reduces bubble volume fraction by ∼35% and increases compressive strength by up to 39%, offering a low‐cost route to stronger printed ...
Runmiao Gao   +10 more
wiley   +1 more source

Home - About - Disclaimer - Privacy