Results 111 to 120 of about 368,690 (301)
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
High Voltage, 2018 A modular multilevel converter (MMC) is one of the promising voltage source converter topologies in the field of high-voltage direct current (HVDC) transmission.
Xiaofeng Yang +4 more
doaj +1 more source
Modal analysis of multiterminal high voltage direct current transmission [PDF]
, 1993 This report describes a first phase of effort in providing the Bonneville Power Administration (BPA) with comprehensive tools for model-based analysis of interactions between the Pacific HVDC Intertie (PDCI) and the alternating current (ac) system containing it. The work builds upon the transient stability model coded by Control Technologies, Inc. (CTI)
openaire +2 more sources
Advanced Engineering Materials, EarlyView.Creep experiments at 900°C on coarse‐grained steel‐ceramic composites containing recycled magnesia reveal that higher ceramic volume fractions significantly enhance the creep resistance. Detailed EBSD investigations identify subgrain formation in the steel matrix as the dominant deformation mechanism.
Moritz Müller +6 more
wiley +1 more source
Transfer-matrix approach to multiband Josephson junctions
, 2006 We study the influence of multiple bands on the properties of Josephson junctions. In particular we focus on the two gap superconductor magnesium diboride.
Dahm, T., Graser, S.
core +1 more source
Influence of an Argon/Silane Atmosphere on the Temperature of a Thermal Plasma
Advanced Engineering Materials, EarlyView.The influence of a silane‐doped argon atmosphere on the chemical composition and temperature of a thermal nontransferring argon plasma is investigated using optical emission spectroscopy. As a result of the high amount of free electrons resulting from the stepwise ionization and dissociation of the silane molecule, even a silane addition of 0.01 vol ...
Lena Kreie +4 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This article presents the design, modeling, and characterization of air‐pressure–actuated programmable vibroacoustic metamaterials (PVAMM). The study focuses on leveraging air pressure to dynamically tune resonance frequencies for effective noise attenuation.
William Kaal +2 more
wiley +1 more source
Effect of Laser Deoxidation on Adhesive‐Bonded Aluminum in an Oxygen‐Free Atmosphere
Advanced Engineering Materials, EarlyView.This study investigates laser ablation of aluminum under oxygen‐free conditions. The goal is to produce oxide‐free substrates that enable improved adhesive bonding with epoxy. Optimized laser parameters (90% overlap, 300 µJ) combined with oxide‐free substrates result in the highest tensile strength of the adhesive bond.
Sandra Gerland +5 more
wiley +1 more source
A Proposed Supergrid Model for National Transmission Network of Pakistan [PDF]
Mehran University Research Journal of Engineering and Technology, 2017 Pakistan is facing a severe energy crisis of its time with significant generation deficit in recent years. The future plan shows hydro and thermal coal generation as major contributor and Wind power to replace Thermal-oil generation in long run.
FAHEEM AKHTER +2 more
doaj
Dephasing due to Which Path Detector
, 1997 We study dephasing of electrons induced by a which path detector and thus verify Bohr's complementarity principle for fermions. We utilize a double path interferometer with two slits, with one slit being replaced by a coherent quantum dot (QD).
Aleiner +19 more
core +2 more sources