Results 121 to 130 of about 16,705,604 (281)

Using situated learning and multimedia to investigate higher-order thinking [PDF]

, 1999
This paper describes a qualitative study into students' use of higher-order thinking as they use an interactive multimedia program based on a situated learning framework.
Oliver, R., Herrington, J.
core  

Hybrid Inertial–Centrifugal Gas–Liquid Separator: CFD‐Driven Optimization Using Coupled Discrete Phase and Wall‐Film Modeling With Response Surface Methodology

Asia-Pacific Journal of Chemical Engineering, EarlyView.
ABSTRACT Efficient removal of liquid aerosols from compressed gas streams is essential in chemical and energy processes. Conventional separators relying on a single mechanism (inertial or centrifugal) struggle to capture both fine and coarse droplets simultaneously.
Son Ung Kang, Phyong Jon Thak, Kyong Jun Ri, Chung Hyok Choe   +3 more
wiley   +1 more source

Higher order asymptotics for negative binomial regression inferences from RNA-sequencing data. [PDF]

Stat Appl Genet Mol Biol, 2013
Di Y, Emerson SC, Schafer DW, Kimbrel JA, Chang JH.   +4 more
europepmc   +1 more source

Residual Strength Prediction of Chemically Reactive Two‐Phase Nanofluid Flow in a Bingham–Papanastasiou Rheological Theory Using a Morlet‐Based Wavelet Neural Network Approach

Asia-Pacific Journal of Chemical Engineering, EarlyView.
ABSTRACT The behavior of nanofluid flow involving a zero‐mass flux condition has received considerable interest because of a realistic scenario. In reality, this condition confines the optimistic accumulation or disappearance of nanoparticles past a sheet, constructing a more physically realistic demonstration through several applications, such as heat
Umair Khan, Hamza Rauf, Aurang Zaib, J. K. Madhukesh   +3 more
wiley   +1 more source

Streamline and Isotherm Visual Analysis of Darcy–Forchheimer von Karman Spinning Flow of Maxwell Fluid Over a Stretching Disk With Quadratic Temperature‐Dependent Heat Source

Asia-Pacific Journal of Chemical Engineering, EarlyView.
ABSTRACT This research paper provides an extensive study of the effects of Darcy–Forchheimer von‐Karman spinning flow of Maxwell fluid across a stretching disk including the effect of heat generation based on a nonlinear function of temperature. The flow system is influenced by thermal radiations and Arrhenius activation energy.
Ebrahem A. Algehyne, Mounirah Areshi, Fahad Maqbul Alamrani, Zehba Raizah, Mustafa Bayram, Jihad Younis, Anwar Saeed   +6 more
wiley   +1 more source

MHD Maxwell Hybrid Nanofluid Transport Featuring Solar Radiation and Thermo‐Diffusive Impacts Over a Permeable Slanted Stretching Sheet

Asia-Pacific Journal of Chemical Engineering, EarlyView.
ABSTRACT Hybrid nanofluids have emerged as next‐generation working fluids for advanced engineering application due to their superior heat transport capability in relation to the conventional nanofluids. Motivated by the rising demand for accurate prediction of transport phenomena under realistic operating situations, the present study examines the ...
B. Prabhakar Reddy, Swatmaram, Jumanne Mng'ang'a, Jason M. Mkenyeleye   +3 more
wiley   +1 more source

Electrokinetic Stabilization of Formation Fines Using Surface Modified Polymer Silica Nanocomposites During Low Salinity Water Flooding for Enhanced Oil Recovery

Asia-Pacific Journal of Chemical Engineering, EarlyView.
ABSTRACT Fines migration induced by low salinity water flooding severely impairs reservoir permeability and injectivity presenting a critical challenge in enhanced oil recovery. This study aims to synthesize and evaluate a surface‐modified polymer‐silica nanocomposite to mitigate clay mobilization and preserve the hydrodynamic capacity of porous media.
Mohamed Abu Shuheil, Dilipkumar S. Patel, N. Beemkumar, Tariq Abdulkader Alrihaim, Dhirendra Nath Thatoi, Ripendeep Singh, Rohit Kumar, Parminder Singh, Ahmad Khalid   +8 more
wiley   +1 more source

Fabrication‐Aware Mechanical Design of SLA‐Printed Polymeric Microneedles: Integrating Geometry, Dimensional Fidelity, and Structural Instability

Journal of Applied Polymer Science, EarlyView.
SLA‐printed microneedles exhibit fabrication‐induced dimensional deviations that strongly influence their mechanical response. Comparison of nominal CAD, global as‐printed, and local critical‐section models shows that local tip‐region geometry provides the closest agreement with experimental instability loads, highlighting the importance of fabrication‐
Rafael C. Otoni, Leandro T. Kochi, Ana Carola D. L. V. Reis, Fabíola L. de Castro, Wendel A. Alves   +4 more
wiley   +1 more source

The morphology of the oval window in Paranthropus robustus compared to humans and other modern primates

The Anatomical Record, EarlyView.
Abstract The oval window (OW) is an opening connecting the inner and middle ear. Its area has been shown to consistently scale with body mass (BM) in primates, and has been used alongside semi‐circular canal (SCC) size to differentiate Homo sapiens and fossil hominins, including Paranthropus robustus.
Ruy Fernandez, José Braga
wiley   +1 more source

Craniofacial growth, modeling, and estimation of milestones

The Anatomical Record, EarlyView.
Abstract Understanding craniofacial growth is foundational for research into intra‐ and interspecies variation, evolution, and clinical care. The Craniofacial Growth Consortium Study (CGCS), combines cephalographs from historical growth studies to create a dense longitudinal record of growth from 6 to 22 years of age.
Richard J. Sherwood, Dana L. Duren, Christina L. Holzhauser, Hee Soo Oh, Manish Valiathan, Kieran P. McNulty, Kevin M. Middleton   +6 more
wiley   +1 more source