Results 91 to 100 of about 203,397 (298)
Advanced Functional Materials, EarlyView.A bespoke multilayer thin film configuration has been designed, which overcomes the material dependency of conventional isotope exchange Raman spectroscopy (IERS). This universal IERS methodology is efficient, non‐destructive and provides additional structural information and time resolution, which can be further extended to various isotopic elements ...
Zonghao Shen +7 more
wiley +1 more source
Growth of Millimeter‐Sized BaTaO2N Single Crystals by an NH3‐Assisted BaCl2 Flux Method
Advanced Functional Materials, EarlyView.Millimeter‐sized BaTaO2N single crystals are successfully grown from a BaCl2 flux under NH3 flow. Their comprehensive characterization, including dielectric properties, is demonstrated, and the possible growth mechanisms are discussed. Abstract Perovskite‐type oxynitrides have attracted considerable attention due to their excellent photocatalytic ...
Ginji Harada +2 more
wiley +1 more source
Grid integration and a power quality assessment of a wave-energy park
IET Smart Grid, 2019 This study presents a step toward the grid connection of a wave-energy park through an electric power conversion system (EPCS) developed and installed for the wave-energy harvesting in Lysekil, Sweden.
Arvind Parwal +10 more
doaj +1 more source
Local Thermal Conductivity Patterning in Rotating Lattice Crystals of Anisotropic Sb2S3
Advanced Functional Materials, EarlyView.Microscale control of thermal conductivity in Sb2S3 is demonstrated via laser‐induced rotating lattice crystals. Thermal conductivity imaging reveals marked thermal transport anisotropy, with the c axis featuring amorphous‐like transport, whereas in‐plane directions (a, b) exhibit 3.5x and 1.7x larger thermal conductivity.
Eleonora Isotta +13 more
wiley +1 more source
EnergiesAccording to standards, the harmonic content should be less than 5% at the time of calibration, while the calibration index proposed in this paper stipulates that the primary current amplitude of 1%~120% of the full range of the accuracy level reaches 0 ...
Can Ding +3 more
doaj +1 more source
Influence of higher-order harmonics on the saturation of the tearing mode
, 2008 The nonlinear saturation of the tearing mode is revisited in slab geometry by taking into account higher-order harmonics in the outer solution. The general formalism for tackling this problem in the case of a vanishing current gradient at the resonant ...
F Militello +4 more
core +1 more source
Advanced Functional Materials, EarlyView.Photomultiplication organic photodetectors (PM OPDs) are an attractive strategy for health‐monitoring. Here, PM‐OPDs are reported with a specific detectivity of 5.7 × 1012 Jones and external quantum efficiency values of 3500% under −10 V. The dynamics of carrier trapping in these devices are elucidated through trap selective spectroscopical techniques.
Marie Houot +9 more
wiley +1 more source
Spectral Interference in High Harmonic Generation from Solids
, 2019 Various interference effects are known to exist in the process of high harmonic generation (HHG) both at the single atom and macroscopic levels. In particular, the quantum path difference between the long and short trajectories of electron excursion ...
Bian, Xue-Bin +7 more
core +2 more sources
Advanced Functional Materials, EarlyView.A FeN4─O/Clu@NC‐0.1Ac catalyst containing atomically‐dispersed FeN4─O sites (medium‐spin Fe2+) and Fe clusters delivered a half‐wave potential of 0.89 V for ORR and an overpotential of 330 mV at 10 mA cm−2 for OER in 0.1 m KOH. When the catalyst was used in a rechargeable Zn–air battery, a power density of 284.5 mW cm−2 was achieved with excellent ...
Yongfang Zhou +8 more
wiley +1 more source
, 2004 Using a fermiology approach to the computation of the magnetic susceptibility measured by neutron scattering in hole-doped high-Tc superconductors, we estimate the effects on the incommensurate peaks caused by higher d-wave harmonics of the ...
Bill, A. +5 more
core +1 more source