Results 21 to 30 of about 10,476 (189)
Investigation on cracking performance of UHPC overlaid concrete deck at hogging moment zone of steel-concrete composite girders [PDF]
Archives of Civil Engineering, 2023 The concrete deck at the negative bending moment region of a continuous steel-concrete composite girder bridge is the weakest part of the structure. Introducing ultra-high performance concrete (UHPC) to the hogging region may overcome the shortage and ...
Zhiyong Wan +5 more
doaj +1 more source
Influence of section depth on the structural behaviour of reinforced concrete continuous deep beams [PDF]
, 2007 YesAlthough the depth of reinforced concrete deep beams is much higher than that of slender beams, extensive existing tests on deep beams have focused on simply supported beams with a scaled depth below 600 mm.
Ashour, Ashraf, Yang, Keun-Hyeok
core +1 more source
Behaviour and design of composite beams subjected to negative bending and compression [PDF]
, 2012 This paper investigates the behaviour of steel–concrete composite beams subjected to the combined effects of negative bending and axial compression. Six full-scale tests were conducted on composite beams subjected to negative moment while compression was
Kirkland, Brenadan +3 more
core +1 more source
NSM technique to increase the load carrying capacity of continuous RC slabs [PDF]
, 2013 This work presents and analysis the results of an ongoing research project on the use of the near surface mounted (NSM) carbon fiber-reinforced polymer (CFRP) laminates for the increase of the load carrying capacity of statically indeterminate (two ...
Barros, Joaquim A. O., Dalfré, Gláucia
core +1 more source
Results in Engineering, 2023 To enhance the safety of ship structure design, this study evaluated time-dependent hull girder ultimate strength considering thick corrosion and the inclination conditions of stiffened panels.
Imaduddin Faqih +5 more
doaj +1 more source
Advances in Civil Engineering, 2020 The results of an experimental and analytical study on the static and fatigue behavior in steel-concrete composite beams under the hogging moment were presented in this paper, and the structural deformation was discussed cautiously and emphatically ...
Aiming Song +3 more
doaj +1 more source
Ultimate permissible additional hogging of a brick wall during the reconstruction of a historical building [PDF]
E3S Web of Conferences, 2022 The paper analyzes the possible development of an approach limiting additional deformations of the base of a building during reconstruction. We consider the ultimate permissible value of additional relative hogging in a brickwork wall without ...
Yevseyev Nikolay +2 more
doaj +1 more source
A parametric study on the effectiveness of the NSM technique for the flexural strengthening of continuous RC slabs [PDF]
, 2012 Recent experimental research has shown that Near Surface Mounted (NSM) technique has high potential to increase the load carrying capacity of continuous reinforced concrete (RC) slabs.
Aiello +18 more
core +1 more source
Applied Sciences, 2018 Twin-I girder bridge systems composite with precast concrete deck have advantages including construction simplification and improved concrete strength compared with traditional multi-I girder bridge systems with cast-in-place concrete deck.
Haiying Ma, Xuefei Shi, Yin Zhang
doaj +1 more source
Numerical analysis of the stress state in a plating floor for a 8000 tdw chemical tanker
Annals of "Dunărea de Jos" University of Galaţi: Fascicle XI Shipbuilding, 2022 The analysis has the purpose to determine the stresses that will occur in the structure un-der unfavorable conditions. Depending on the results, intervention will be made upon the structure to ensure the resistance of the vessel, optimizing of the ...
Alina Mihaela Năstasă +1 more
doaj +1 more source