Results 21 to 30 of about 1,269 (154)
Investigative Study on the Properties of Hollow Concrete Blocks
International Journal of Innovative Research in Computer Science & Technology, 2022 The utilization of workmanship structures is as yet broad all through the world. Hollow concrete blocks have supplanted customary bricks in late development as a result of the upsides of higher bearing limit, farmland insurance, and energy protection [1].
openaire +1 more source
Thin layer concrete blockwork in compression: an experimental analysis
Engineering Structures and Technologies, 2015 The compressive strength of concrete block masonry is dependent upon the unit compressive strength, the type of unit, the mortar and the form of masonry construction (Mirza et al. 1995).
Ayman Trad +3 more
doaj +1 more source
Lightweight concrete masonry blocks produced with: tire rubber and metakaolin
Revista Ingeniería de Construcción, 2020 This paper presents the evaluation of lightweight concrete masonry blocks, incorporated with tire rubber and metakaolin, aiming reduce its bulk density and obtaining dimensional values of compressive strength and water absorption in according to the ...
C. Fioriti +4 more
doaj +1 more source
Hollow Concrete Building Blocks: Their Manufacture and Use [PDF]
Scientific American, 1905 n ...
openaire +2 more sources
, 2009 Hollow block walls, whether originally built with external render and internal plaster, or more recently with external render and insulated drylining, represent the most common form of wall construction in Leinster over the last 50 years (see image in Figure 8).
Little, Joseph +1 more
openaire +4 more sources
Life-Cycle Assessment of Lightweight Partitions in Residential Buildings
BuildingsThe aim of this study was to evaluate the impact of service conditions on lightweight partitions in residential buildingsusing life-cycle assessments (LCAs).
Svetlana Pushkar
doaj +1 more source
Журнал інженерних наук, 2023 Fire tests of reinforced concrete floor slabs do not allow the detection of the onset of the boundary state due to loss of entirety because blocks are installed on the unheated surface to reproduce the design load.
Sidnei S. O. +4 more
doaj +1 more source
Investigation of the mechanical and thermal performances of concrete hollow blocks [PDF]
SN Applied Sciences, 2020 In order to improve the thermal performance of external masonry walls, the impact of the blocks’ internal configuration on both their mechanical strength and thermal properties is numerically investigated. Ten different configurations with approximatively similar void ratios of about 40% (38.25–40.5%) and same external dimensions (40 cm × 20 cm × 10 cm)
Sassine, Emilio +3 more
openaire +3 more sources
Concrete Hollow Block with Reused Glass
Nusantara Civil Engineering JournalConcrete is being used a lot in construction. As urbanization accelerates globally, the demand for sustainable construction materials is becoming increasingly critical. Traditional concrete, a staple in the construction industry, is known for its environmental impact due to high energy consumption in production and the extensive use of natural ...
Yuhani Jamian, Munirah Abd Rahim
openaire +1 more source
A Discussion about the Rod Position in the Splitting Tensile Tests on Hollow Concrete Blocks
Buildings, 2022 Different loading conditions cause different tensile stress patterns in masonry structures. Several studies related to masonry behavior use indirect tensile tests to obtain that value, where the splitting test from ASTM-C-1006 is usually employed.
Jorge H. Chávez-Gómez +5 more
doaj +1 more source