Results 191 to 200 of about 217,267 (313)

Comparison of Triply Periodic Minimal Surface Energy Absorbers Under Uniaxial Compressive Loading

Advanced Engineering Materials, EarlyView.
This study investigates LCD 3D printed Triply Periodic Minimal Surface (TPMS) structures as mechanical energy absorbers. By comparing various base designs and layered combinations under uniaxial compression, it identifies that a Diamond‐Gyroid sandwich structure offers superior performance.
Sergej Grednev, Noah‐Lean Roschlaub, Anne Jung   +2 more
wiley   +1 more source

Conformal Coordinates for Molecular Geometry: From 3D to 5D. [PDF]

J Comput Chem
Camargo J, Lavor C, Souza M.
europepmc   +1 more source

Parallel submanifolds of complex projective space and their normal holonomy [PDF]

, 2009
S. CONSOLE, Console, S., Di Scala, Antonio Jose'   +2 more
core  

Microstructure, Thermal Transport, and Dry‐Sliding Tribology of Powder‐Metallurgy Al7075 Composites Reinforced With Sol–Gel‐Derived ZnO–rGO Hybrid Nanoparticles

Advanced Engineering Materials, EarlyView.
Sol–gel‐derived ZnO–rGO hybrid nanoparticles enable Al7075 powder‐metallurgy composites to achieve concurrent gains in hardness and thermal conductivity while markedly lowering friction and wear. The hybrid architecture couples ZnO‐based load support with rGO‐assisted lamellar sliding and heat spreading, revealing a promising route toward lightweight ...
Bunyamin Aksakal, Cevher Kursat Macit, Merve Ayık, Hakan Tutumlu   +3 more
wiley   +1 more source

Dimensional cophenetic integrity: a method for evaluation of dimensionality reduction in MSI. [PDF]

Bioinform Adv
Newstead CJ, Bunch J, Bailey MJ, Dexter A.   +3 more
europepmc   +1 more source

Every finite-dimensional analytic space is $\sigma$-homogeneous

All spaces are assumed to be separable and metrizable. Building on work of van Engelen, Harrington, Michalewski and Ostrovsky, we obtain the following results: (1) Every finite-dimensional analytic space is $\sigma$-homogeneous with analytic witnesses ...
Agostini, Claudio, Medini, Andrea
core  

Advanced Electron Microscopy and Microcomputed Tomography Analysis of Single‐Crystal Ni‐Base Superalloys After Short‐Term Multiaxial Creep

Advanced Engineering Materials, EarlyView.
This work studies the anisotropic behavior of circular notched tensile specimens of Ni‐base superalloy single crystals during high‐temperature tensile creep along [001], [110], and [111]. Correlative scale‐bridging imaging of specimens reveals early rupture along [110] because 1) plastic deformation proceeds faster at notch center; 2) more (brittle ...
Leonardo Agudo Jácome, Lijie Cao, Christoph Somsen, Johannes Boes, René Hesse, Werner Theisen, Gunther Eggeler   +6 more
wiley   +1 more source

Numerical Simulations of the Superfluid 3 He Order Parameter Using dyGiLa: A Homogeneous Rapid Quench to B Phase. [PDF]

J Low Temp Phys
Lopez-Eiguren A, Hindmarsh M, Rummukainen K, Zhang K.   +3 more
europepmc   +1 more source

Defect Evolution and Mechanical Performance of Fused Filament Fabrication‐Manufactured 17‐4PH Stainless Steel Revealed by X‐Ray Computed Tomography

Advanced Engineering Materials, EarlyView.
X‐ray computed tomography reveals how process‐induced defects evolve from green to sintered states in Fused Filament Fabrication (FFF)‐manufactured 17‐4PH stainless steel. Internal porosity, weakest cross‐sections, and fracture locations show strong correlation with tensile performance, demonstrating the potential of computed tomography (CT)‐based ...
György Ledniczky, Márk Sárközi, Ibolya Zsoldos, Zoltán Weltsch   +3 more
wiley   +1 more source

A case of bilateral calcified subdural hematomas with midline shift in a patient with a chronic Lumboperitoneal shunt. [PDF]

Oxf Med Case Reports
Ali A, Tanveer A, Yousuf D, Ghafoor LA, Sharma MK.   +4 more
europepmc   +1 more source