Results 131 to 140 of about 39,105 (252)
Procedure for the Experimental Determination of a Forming Limit Curve for Usibor 1500 P
, 2007 International audienceUSIBOR 1500 P® is a coated C-Mn steel, micro-alloyed with boron, with excellent processing properties in hot stamping, both in terms of formability, quenchability and surface protection, and leading to superior mechanical properties
Chastel, Yvan +5 more
core +1 more source
An Investigation, Using Standard Experimental Techniques, to Determine FLCs at Elevated Temperature for Aluminium Alloys [PDF]
, 2012 An experimental procedure has been developed for the determination of FLCs at elevated temperatures. The GOM ARGUS system was employed for measuring surface strain based on pre-applied grids (pattern), and limit strains were determined according to the ...
Balint, D +6 more
core
Specifications, quality control, manufacturing, and testing of accelerator magnets
, 2011 The performance of the magnets plays an important role in the functioning of an accelerator. Most of the magnets are designed at the accelerator laboratory and built by industry.
Einfeld, D.
core +1 more source
Simulation of hot stamping processes
, 2008 Hot stamping is a thermo-mechanical technique that enables to give to a metallic blank the desired geometry and properties in a single step, where deformation at high temperature, phase transformations and heat transfer are occurring simultaneously and affect mutually.
Riera Colom, María Dolores +4 more
openaire +1 more source
steel research international, EarlyView.On the pathway to climate‐neutral steel production, recycling fractions will necessarily increase over time. Since alloying elements will enrich progressively, as they cannot be removed economically from the melt, processes need to be adjusted.
Anindita Chakraborty +3 more
wiley +1 more source
Multi-Objective Optimization of Process Parameters in 6016 Aluminum Alloy Hot Stamping Using Taguchi-Grey Relational Analysis. [PDF]
Materials (Basel), 2022 Jiang B, Huang J, Ma H, Zhao H, Ji H.
europepmc +1 more source
Development and testing of the Shenandoah collector [PDF]
, 1981 The test and development of the 7-meter Shenandoah parabolic dish collector incorporating an FEK-244 film reflective surface and cavity receiver are described. Four prototypes tested in the midtemperature Solar System Test Facility indicate, with changes
Kinoshita, G. S.
core +1 more source
steel research international, EarlyView.The study investigates the influence of DED‐Arc/M versus casting on the microstructure and material properties of X40CrMoV5‐1 (AISI H13) hot‐work tool steel. DED‐Arc/M yields finer microstructures, superior mechanical strength, and ductility, but slightly reduced thermal conductivity.
Ulf Ziesing +4 more
wiley +1 more source
Analysis of Hot Stamping Tool Cooling System-A Case Study. [PDF]
Materials (Basel), 2021 Danielczyk P, Wróbel I.
europepmc +1 more source
Micropatterned Surfaces with Unidirectional Wetting Properties for Liquid Transport
Small Structures, EarlyView.Micropatterned surfaces that guide droplets in a single direction are gaining attention for their role in liquid transport. This review explores how surface designs enable such behavior, from gravity‐driven flow to stimulus‐responsive movement. It also discusses fabrication techniques, design challenges, and emerging strategies to advance directional ...
Elham Lori Zoudani +5 more
wiley +1 more source