Results 101 to 110 of about 10,869 (179)
Some of the next articles are maybe not open access.
Hot-tearing susceptibility of Mg–9Al–xZn alloy
Materials Letters, 2002Abstract Hot-tearing susceptibility of Mg–9Al– x Zn alloys is studied. Crack-ring molds were used to test the hot-tearing susceptibility. In situ thermal analysis, optical microscopy, scanning electron microscopy (SEM) and line scan were used to examine the hot-tearing behavior.
Guohua Wu, Qudong Wang, Wenjiang Ding
exaly +2 more sources
Improvement of yttrium on the hot tearing susceptibility of 6TiB2/Al-5Cu composite
Journal of Rare Earths, 2015Abstract To improve the severe hot tearing susceptibility of TiB 2 reinforced Al-5Cu matrix composites, the present research investigated the influence of Y on the hot tearing susceptibility of 6TiB 2 /Al-5Cu composite. For the composite added with Y, the solidification temperature range was shortened, which was caused by the novel τ 1 -Al 8 Cu 4 Y ...
Yijie Zhang +2 more
exaly +2 more sources
Effect of Cu on the Hot Tearing Susceptibility of Al–6Zn–2.5Mg–xCu Alloy
International Journal of Metalcasting, 2020Based on the modified Clyne–Davies model and the “T”-type hot tearing test system, the hot tearing susceptibility of Al–6Zn–2.5Mg–xCu (x = 0, 1, 2, 3 wt%) alloy was predicted and verified. The results showed that the hot tearing susceptibility first decreased and then increased with the increase in the content of Cu, and the smallest was at the content
, Chen Yongqiang
exaly +2 more sources
Simulating the hot tearing susceptibility of steel cast flange
International Journal on Interactive Design and Manufacturing (IJIDeM), 2023M. Ivanov
semanticscholar +2 more sources
Effect of Ca/Al ratio on hot tearing susceptibility of Mg–Al–Ca alloy
Journal of Alloys and Compounds, 2022Feng Wang, Pingli Mao, Le Zhou
exaly +2 more sources
Effect of Ca on hot tearing susceptibility of WE43 alloy
Journal of Alloys and CompoundsXin Guo +9 more
semanticscholar +2 more sources
Crack formation of camshaft castings: Hot tearing susceptibility and root causes
Engineering Failure Analysis, 2023Yankang Zhu +7 more
semanticscholar +2 more sources
Effect of AlN reinforcement particles on hot-tearing susceptibility of AlN/AZ91D composites
Materials Today Communications, 2023, Yunxia Sun
exaly +2 more sources
A Review on the Criteria of Hot Tearing Susceptibility of Aluminum Cast Alloys
International Journal of Metalcasting, 2021The development of new alloys characterized by a high strength-to-weight ratio and low production costs is one of the major objectives of the modern automotive industry with a view to lowering CO2 emissions and obtaining automotive castings that are both lightweight and capable of maintaining their performance under elevated temperature service ...
A. M. Nabawy +3 more
openaire +1 more source
Hot tear susceptibility of aluminium–silicon binary alloys
International Journal of Cast Metals Research, 2010AbstractHot tear susceptibility (HTS) of Al–Si alloys in the 0–5–3·0 wt-%Si has been determined using a constrained rod casting test and a quantitative index. Hot tear susceptibility was seen to decrease with increasing silicon content. Hot tear severity varied directly with solidification shrinkageβ, the non-equilibrium freezing range ΔT′, dendrite ...
M. O. Pekguleryuz +4 more
openaire +1 more source