Results 171 to 180 of about 149,170 (267)

Research on Heat Transfer Enhancement of Spiral Grooved Tube Heat Exchangers Based on CFD and Artificial Intelligence

Asia-Pacific Journal of Chemical Engineering, EarlyView.
ABSTRACT Driven by the energy crisis and carbon neutrality goals, high‐efficiency heat exchange equipment has become a core demand in the industrial sector. The spiral grooved double‐pipe heat exchanger exhibits significant heat transfer enhancement advantages, yet it requires balancing heat transfer efficiency and pressure loss.
Yueyun Yang, Wei Li, Xiuzhi Xi, Neng Gao
wiley   +1 more source

The Effect of 'Hydraulic-Visual' Interaction on the Intensity of Fish Schooling in the Upstream Movement of Juvenile Silver Carp. [PDF]

Ecol Evol
Haoyu D, Chenyu L, Yujiao W, Zijing Y, Xiaotao S, Zezhang L, Guiwen R, Jiawei X, Jia L, Lixiong Y.   +9 more
europepmc   +1 more source

Linear Viscoelastic Behavior of n‐Alkane Diluted Polyethylene Melts: Sorption, Desorption, and Oscillatory Rheometry

Journal of Applied Polymer Science, EarlyView.
This study systematically maps polyolefin dilution dynamics using a homologous series of n‐alkanes. Integrating gravimetric sorption, subsequent controlled desorption, and oscillatory rheometry establishes a precise framework to analyze reduction in viscosity at least for polymer diluent mixtures with polymer concentration > 35% and diluent ...
Ernst Georg Viehböck, Georg Gschwendner, Dario Pindrić, Gunnar Spiegel, Alexander Hammer, Christian Paulik, Gerald Berger‐Weber   +6 more
wiley   +1 more source

Design and control strategy of a heavy-duty independent suspension system based on distributed hydraulic sources. [PDF]

Sci Prog
ShiCheng Z, Sijia C, Jingkun W, Jihong Z, Xiaming Y.   +4 more
europepmc   +1 more source

Long‐Time Thermal Aging of Perfluoroalkoxy Polymers for Electrical Insulation: Structural and Physical Properties Evolutions

Journal of Applied Polymer Science, EarlyView.
This work focuses on the investigation of the influence of a long‐time exposition to accelerated thermal aging on the physicochemical structure and properties of PFA. Results show a decrease in the melting temperature and crystal ratio due to chemical aging.
Victor Henri, Julien Chedaille, Pierre Henrard, Eric Dantras   +3 more
wiley   +1 more source

Correction: Enhanced characterization of hydraulic conductivity via standard penetration test for sandy soils and weathered rocks. [PDF]

Sci Rep
Seo W, Yang E, Yun TS.
europepmc   +1 more source

Valorization of Post‐Consumer Waste From Metallized Flexible Packaging and Industrial EPM Waste: Development of Sustainable Composites

Journal of Applied Polymer Science, EarlyView.
Post‐consumer metallized flexible packaging waste and industrial EPM waste are transformed into sustainable composites through mechanical recycling. The incorporation of 30 wt% EPM provides the most favorable balance between stiffness, ductility, and impact resistance, achieving 53.36 kJ/m2.
Tiago O. Oliveira, Samara L. Santos, Ruth M. C. Santana   +2 more
wiley   +1 more source

Response Surface Analysis of Thermo-Hydraulic Performance of a Direct Absorption Solar Receiver Using Fe₃O₄ Nanofluid Under Concentrated Solar Irradiation. [PDF]

Nanomaterials (Basel)
Ham J, Kim H, Ryu SB, Cho H.
europepmc   +1 more source

Fibrillisation and Mechanical Properties of Plasma‐Treated Modification LDPE/PA6 Microfibrillar Composites

Journal of Applied Polymer Science, EarlyView.
Plasma treatment enhances interfacial adhesion between LDPE/PA6 via carbonyl group formation. PA6 droplet size heterogeneity reduced to ~850 nm after plasma treatment. Drawing at 160°C produces highly oriented microfibrils with faster throughput. Plasma‐treated MFCs show up to 500% tensile strength increase and 18% higher stiffness.
Narges Gray, Maximillian Pitto, Nam Kyeun Kim, Casparus Johannes Reinhard Verbeek, Simon Bickerton   +4 more
wiley   +1 more source

Water flux patterns and aquaporin dynamics: linking stomatal demand to root hydraulics in pearl millet hybrids. [PDF]

Front Plant Sci
Medina S, Kakkera A, Reddy PS, Vadez V.
europepmc   +1 more source