Results 61 to 70 of about 189,797 (303)
An evaluation of earth banked tanks for slurry storage [PDF]
End of project reportThis study examines the feasibility of using earth-banked tanks (EBT’s) as an alternative and economical means of winter storage for animal and other farmyard wastes.
Crosse, Seamus +5 more
core
This study reports the fabrication of MRI‐compatible elastomeric micro‐balloons via a multi‐step bubble casting process, where the monolithic elastomeric wall is selectively stiffened for reversible and controlled inflation and elasticity, depending on the target vessels for graded occlusion of cerebral arteries.
Jong Bin Kim +10 more
wiley +1 more source
Full- and Reduced-order Model of Hydraulic Cylinder for Motion Control [PDF]
This paper describes the full- and reduced-order models of an actuated hydraulic cylinder suitable for system dynamics analysis and motion control design.
Ruderman, Michael
core +2 more sources
Applications of digital core analysis and hydraulic flow units in petrophysical characterization
Conventional petrophysical characterizations are often based on direct laboratory measurements. Although they provide accurate results, such measurements are time-consuming and limited by instrument and environment. What’s more, in the geo- resource energy industry, availability and cuttings of core plugs are difficult. Because of these reasons, virtual
Xiaojun Chen, Yingfang Zhou
openaire +1 more source
Understanding Operando Water Management in Hydroxide‐Exchange‐Membrane Fuel Cells
Effective water management is vital for high‐performance hydroxide‐exchange‐membrane fuel cells. Using a custom water‐flux station, this study quantifies how membrane thickness, microporous layers, and operating conditions dictate internal water transport.
Catherine M. Weiss +4 more
wiley +1 more source
The successful application of enhance oil recovery (EOR) technology requires an accurate understanding of the internal architecture of reservoirs and complex distribution of flow unit characteristics within different lithofacies.
I. Yusuf, E. Padmanabhan
doaj +1 more source
Dissolved noble gases and stable isotopes as tracers of preferential fluid flow along faults in the Lower Rhine Embayment, Germany [PDF]
Groundwater in shallow unconsolidated sedimentary aquifers close to the Bornheim fault in the Lower Rhine Embayment (LRE), Germany, has relatively low δ2H and δ18O values in comparison to regional modern groundwater recharge, and 4He concentrations up to
A Mayer +65 more
core +1 more source
Hydrogel‐Based 3D‐Printable Stretchable Pressure Sensor
We present a carbon‐black‐functionalized double‐network granular hydrogel (DNGH) pressure sensor capable of detecting pressures from 200 Pa, equivalent to a light finger touch, up to 500 kPa. The sensor exhibits signal drifts below 3.5% after 800 cycles and response times around 80 ms. Leveraging this broad sensing range, we 3D print this material into
Tianyu Yuan +4 more
wiley +1 more source
The Upper Arab reservoir in the central Persian Gulf was examined for depositional, diagenetic, sequence stratigraphic and petrophysical features. This succession is composed of eight sedimentary facies that deposited on a carbonate ramp.
Masoud Sharifi-Yazdi +4 more
doaj +1 more source
CAPILLARY BARRIER SIZING BASED ON HYDRAULIC FLOW UNIT CONCEPT
This paper proposes a method for estimating the height of a type I capillary barrier based on the concept of hydraulic flow units. It was noted in the work that taking into account capillary effects in the formation is relevant and in demand when performing work on estimating reserves, designing a development system and planning various geological and ...
Sh.Kh. Sultanov +5 more
openaire +1 more source

