Results 1 to 10 of about 96,883 (287)

Joint simulation and experimental verification of electromechanical-hydraulic of hydraulic excavator working device [PDF]

open access: yesScientific Reports
To rigorously evaluate the electromechanical-hydraulic coupling performance of a hydraulic excavator’s working device under authentic operating loads, this study presents a field-data-driven co-simulation framework applied to a 20-ton backhoe hydraulic ...
Mei Xin   +6 more
doaj   +2 more sources

A study on stabilization of operation time for hydraulic operating circuit breaker (Investigation of synchronous / sequential operation system of two high speed hydraulic operating devices)

open access: yesNihon Kikai Gakkai ronbunshu, 2016
Two driving systems in which a circuit breaker is driven synchronously and sequentially by two devices which are connected with relatively long hydraulic pipes were investigated.
Tohru YAMASHITA   +4 more
doaj   +3 more sources

Designing Hydraulic Impact Devices for Low-Temperature Operation

open access: yesJournal of Physics: Conference Series, 2021
Abstract The paper is devoted to the results of theoretical studying the hydraulic jackhammer operation under various temperature conditions and practical recommendations for their design and operation, considering the temperature factor.
R A Redelin, Y N Kamanin, A V Panichkin
openaire   +1 more source

Research on transmission control method of tension tower hydraulic tension device based on PLC

open access: yesJournal of Applied Science and Engineering, 2023
Using the traditional method to control the transmission process of the tension tower hydraulic tightening device, there is a problem of slow speed step response in the range of device operating speed from 12km/h to 32km/h.
Jinghui Zhang   +3 more
doaj   +1 more source

Incorporation of Fluid Compressibility into the Calculation of the Stationary Mode of Operation of a Hydraulic Device at High Fluid Pressures [PDF]

open access: yesNelineinaya Dinamika, 2021
This paper is concerned with assessing the correctness of applying various mathematical models for the calculation of the hydroshock phenomena in technical devices for modes close to critical parameters of the fluid. We study the applicability limits of the equation of state for an incompressible fluid (the assumption of constancy of the medium density)
Raeder, T.   +2 more
openaire   +2 more sources

Utilization of the tractor hydraulic device to operate reciprocating mowers [PDF]

open access: yesJournal of Soil Sciences and Agricultural Engineering, 2019
Due to the ease and excellence of the hydraulic transmission, this research is concerned to transmit power from tractor to a reciprocating mower using a hydraulic cycle. The theoretical consideration and the previous results from different studies were used to determine a suitable of a hydraulic motor, which give a sufficient torque needed to cutting ...
O. Fouda, M. Awad, Y. Yusuf
openaire   +1 more source

Modeling operation of sliding valve distribution in hydraulic percussion device with adjustable blow energy

open access: yesIOP Conference Series: Earth and Environmental Science, 2021
Abstract The authors discuss the simulation model of a sliding valve distributor enabling adjustment of capabilities of hydraulic percussion devices. The paper presents the theoretical oscillograms of the valve characteristics and the plots of change in the valve mode versus the valve parameters.
LV Gorodilov, AI Pershin
openaire   +1 more source

Automated stand for the study of injectors made of polymer materials for hydraulic weed destruction [PDF]

open access: yesE3S Web of Conferences, 2020
The work describes a new technological process for weed destruction and tillage in the near-stem zones of fruit trees and covers the prospects for studying the hydraulic method of weed destruction.
Khort Dmitriy   +3 more
doaj   +1 more source

Pressure, Flow Rate and Operating Speed Characteristics of a Continuous Flow Left Ventricular Assist Device During Varying Speed Support

open access: yesIEEE Access, 2020
Hydraulic performance of Continuous Flow Left Ventricular Assist Devices depends on their pressure head and flow rate relations. Hydraulic characteristics of these devices are expressed by pressure head and flow rate loops in a pulsatile environment as ...
Selim Bozkurt
doaj   +1 more source

Design of a laboratory hydraulic device for testing of hydraulic pumps

open access: yesActa Universitatis Agriculturae et Silviculturae Mendelianae Brunensis, 2013
The present contribution deals with solves problem of research of testing device to monitor of hydrostatic pumps durability about dynamic loading under laboratory conditions.
Pavel Máchal   +6 more
doaj   +1 more source

Home - About - Disclaimer - Privacy