Results 61 to 70 of about 10,045 (206)
, 2020 This paper provides a study of a flap-type wave energy converter with a hydraulic power-take-off (PTO) system. This study includes the derivation of its equation of motion along with an analysis of natural frequencies of the device. A prototype was built using fillable cylinders and a series of experiments were performed in a wave flume.
openaire +2 more sources
Test 2074: John Deere 5085E [PDF]
, 2013 ABOUT THE TEST REPORT AND USE OF THE DATA The test data contained in this report are a tabulation of the results of a series of tests. Due to the restricted format of these pages, only a limited amount of data and not all of the tractor specifications ...
Nebraska Tractor Test Lab,
core +1 more source
A Review on Sensor‐Integrating Machine Elements
Advanced Sensor Research, Volume 3, Issue 4, April 2024.This contribution summarizes the current state of research regarding sensor‐integrating machine elements as an enabler of digitalization in mechanical engineering. The focus is on the methodical aspects of the development of these machine elements in general as well as specific sensor‐integrating machine elements that are either already in use or ...
Eckhard Kirchner +42 more
wiley +1 more source
Experimental Capture Width Ratio on Unit Module System of Hybrid Wave Energy Converter for Nearshore
Applied Sciences, 2022 This study proposes a new hybrid wave energy converter composed of a horizontal cylinder and a swing plate to improve the capture width ratio. The horizontal cylinder generates electrical energy by using the potential energy of the incident wave, whereas
Min-Su Park +2 more
doaj +1 more source
Test 2200A: New Holland Workmaster 70 [PDF]
, 2018 ABOUT THE TEST REPORT AND USE OF THE DATA The test data contained in this report are a tabulation of the results of a series of tests. Due to the restricted format of these pages, only a limited amount of data and not all of the tractor specifications ...
Nebraska Tractor Test Lab,
core +1 more source
Oscillating body wave energy conversion efficiency based on Simulink simulation training
Energy Science &Engineering, Volume 12, Issue 4, Page 1411-1421, April 2024.The wave energy conversion efficiency has been calculated based on Simulink simulation training, and a maximum output power of 8.1 W has been gained as the corresponding linear damping is 21,000 N s/m. Abstract With the development of the economy and society, we are faced with the dual challenges of energy demands and environmental pollution. As one of
Yue Yin +7 more
wiley +1 more source
Energy ReportsOcean waves represent a substantial renewable energy source, prompting this study's exploration of harnessing this potential via multi-point floating absorbers equipped with hydraulic Power Take-Off (PTO) systems.
Kurniawan T. Waskito +5 more
doaj +1 more source
Multi-Criteria Decision Making Based in Choosing an Appropriate Tractor
Journal of Agricultural Machinery, 2011 Agricultural mechanization goal is to maximize the utility. Establishment of subsidies systemization and Iran incorporation with World Target Organization (WTO), choosing an appropriate technology will be more important.
M.B Lak, A.M Borghaee
doaj +1 more source
IET Renewable Power Generation, 2021 A flume experimental study of a two‐body wave energy converter (WEC) with a hydraulic power take‐off (PTO) was conducted under the conditions of both regular and irregular waves.
Shuang Wu, Yanjun Liu, Jian Qin
doaj +1 more source
Test 2202: John Deere 6215R AutoQuad-Plus [PDF]
, 2018 ABOUT THE TEST REPORT AND USE OF THE DATA The test data contained in this report are a tabulation of the results of a series of tests. Due to the restricted format of these pages, only a limited amount of data and not all of the tractor specifications ...
Nebraska Tractor Test Lab,
core +1 more source