Results 141 to 150 of about 655,526 (298)

Evaluation of Pervaporation and Nanofiltration Membranes for Water Recovery From Thermo‐Responsive Draw Solution

Chemie Ingenieur Technik, EarlyView.
Integrating thermo‐responsive draw solutions with suitable water‐recovery technologies could enable more efficient hybrid desalination. This study compares pervaporation and nanofiltration, revealing key trade‐offs between water productivity and polymer retention and providing guidance for future FO‐based brine treatment systems.
Nadin Al‐Jariry, Malwin Uthleb, Ibrahim M. A. ElSherbiny, Hannes Richter, Liang Yu, Frank Lipnizki, Josefine Enman, Annelie Hedström, Marcus Weyd, Jonas Hedlund   +9 more
wiley   +1 more source

DEVELOPMENT OF HYDRAULIC WATER PUMPING DEVICE DEVELOPMENT OF HYDRAULIC WATER PUMPING DEVICE

, 2015
This thesis presents new development of hydraulic water pumping device, with necessary design equations and steps to design mechanical and hydraulic features of the device. The main working parts of the device are waterwheels, shaft and belt, along that the working principle of the device involves rotary motion of shaft and waterwheels, and alternative
openaire   +1 more source

Economic and environmental implications of the development of UASB reactors in Mexico for sustainable industrial wastewater treatment

The Canadian Journal of Chemical Engineering, EarlyView.
Abstract The objective of this work is to demonstrate that the inclusion of an up‐flow anaerobic sludge bed (UASB reactor) within an industrial wastewater treatment plant reduces the plant's investment and operating costs compared to a system based solely on conventional complete‐mix activated sludge (CMAS), operating under the same design principles ...
Juan Manuel Morgan‐Sagastume, Adalberto Noyola   +1 more
wiley   +1 more source

Development of a sustainable water treatment process using biochar as substrate for filtration and coliform removal

The Canadian Journal of Chemical Engineering, EarlyView.
Preparation, modification, and characterization of biochar from woodchips and its application in stream water filtration, evaluated through physicochemical and microbiological analyses. Abstract Global microbial water contamination affects 1.8 billion people, necessitating efficient and sustainable treatment methods.
Tariq Khalil, Muhammad Ishtiaq Ali, Rameesha Abid, Anab Mujtaba, Rabia Asghar, Asif Jamal, Yusuf Tutar, Ahsan Habib, Fakhraddin Yusubov   +8 more
wiley   +1 more source

Waste activated sludge high‐rate treatment of septage: Stabilization phase trials and comparison with winery wastewater treatment

The Canadian Journal of Chemical Engineering, EarlyView.
Performance evaluation of the waste activated sludge high‐rate (WASHR) process for septic wastewater treatment. Abstract The waste‐activated sludge high‐rate (WASHR) process is evaluated as a batch‐mode pre‐treatment for actual septage using a high‐rate contact stabilization (HRCS) approach.
Arman Shirali, Melody Blythe Johnson, Mehrab Mehrvar   +2 more
wiley   +1 more source

Review of CFD modelling techniques for single‐phase and multiphase flow in static mixers

The Canadian Journal of Chemical Engineering, EarlyView.
This review synthesizes computational fluid dynamics (CFD) approaches for static mixers, linking hydrodynamics to pressure drop, particle/droplet distributions, mixing metrics, and heat‐transfer performance to guide modelling choices and design decisions. Abstract Static mixers enable compact and low‐energy intensification.
Jussan Jaeger, Sálvio Lima de Carvalho Neto, Silvio Edegar Weschenfelder, Glaucia Rodrigues Vieira de Almeida da Fonseca, Maria de Fátima Rodrigues da Cunha, Selene Maria Arruda Guelli Ulson de Souza, Evandro Balestrin, Adriano da Silva   +7 more
wiley   +1 more source

Curriculum alignment with international graduate attribute standards in engineering education: The CPUT experience

The Curriculum Journal, EarlyView.
Abstract This paper presents a qualitative case study of how the Mechanical Engineering Diploma programme at Cape Peninsula University of Technology (CPUT) systematically aligned its curriculum with both national and international graduate attribute (GA) standards.
Ali Rugbani, Simphiwe Nqabisa
wiley   +1 more source

Modeling and experimental validation of bolt–grout bond–slip behavior for deep underground excavation support

Deep Underground Science and Engineering, EarlyView.
A novel shear‐lag model, validated by pull‐out tests, incorporates a constant bond stress stage to predict the complete load–displacement response of grouted rock bolts, providing a new tool for optimizing anchorage length and material toughness in deep underground engineering. Abstract The stability of rock masses in deep underground excavations, such
Wenhui Bian, Xiaohui He, Kexue Wang, Yufei Wu, Guoxin Wang, Shaochen Zhang, Jun Yang   +6 more
wiley   +1 more source

Performance assessment of a potential underground thermal storage facility: Case study of the closed mine Prosper‐Haniel in the Ruhr coal mining area in Germany

Deep Underground Science and Engineering, EarlyView.
This study demonstrates the feasibility of an underground closed‐loop thermal storage facility at a post‐mining site, intended for seasonal heat energy storage. Its principal design shows water flow directions in winter and summer (1, 2), heat pumps (3), an upper water reservoir (4), and connecting pipes (5).
Dmytro Rudakov, Oleksandr Inkin
wiley   +1 more source

Carbon emission assessment of tunnel infrastructures: From construction to operation

Deep Underground Science and Engineering, EarlyView.
This study develops a lifecycle carbon accounting framework for tunnel infrastructures, covering design, construction, operation, maintenance, and dismantling. Applied to a subsea tunnel case, the framework reveals the carbon emission distribution among four typical tunnel types and highlights potential carbon offset methods for low‐carbon tunnel ...
Luyuan Long, Wout Broere, Xuehui Zhang, Tian Xia, Richard de Nijs   +4 more
wiley   +1 more source