Results 111 to 120 of about 13,723 (263)

Design load analysis for electrification of a 55-kW agricultural tractor based on workload. [PDF]

Sci Rep
Baek SM, Jeon HH, Kim WS, Kim YS, Kim YJ.   +4 more
europepmc   +1 more source

Performance assessment of a potential underground thermal storage facility: Case study of the closed mine Prosper‐Haniel in the Ruhr coal mining area in Germany

Deep Underground Science and Engineering, EarlyView.
This study demonstrates the feasibility of an underground closed‐loop thermal storage facility at a post‐mining site, intended for seasonal heat energy storage. Its principal design shows water flow directions in winter and summer (1, 2), heat pumps (3), an upper water reservoir (4), and connecting pipes (5).
Dmytro Rudakov, Oleksandr Inkin
wiley   +1 more source

The electrofluidic brain as a basement layer for neural computation. [PDF]

Commun Biol
Chakravarthy VS, Chandrasekaran V, Shanbhag NC.   +2 more
europepmc   +1 more source

Seismic analysis and design of tunnels within fault ground: A review

Deep Underground Science and Engineering, EarlyView.
The research methods of seismic response of tunnels within fault ground, including field investigations, analytical solutions, physical experiments, and numerical simulations, and seismic countermeasures are discussed. The present study examines the shortcomings and limitations of the current research and design, and puts forward proposals for future ...
Xingda Wang, Yujing Jiang, Xuepeng Zhang, Yuyong Jiao, Ningbo Li, Xiao Wang, Bo Li   +6 more
wiley   +1 more source

Research on the design of non-destructive assembly and disassembly interference fit for aircraft engines. [PDF]

Sci Rep
Fu W, Wang D, Wang Z.
europepmc   +1 more source

Dynamic response at the terminus of oblique intersecting joints subjected to stress waves

Deep Underground Science and Engineering, EarlyView.
This study derives the propagation equation for stress waves impinging upon nonlinear oblique intersecting joints. It analyzes the dynamic response at the terminus of nonlinear oblique intersecting joints subjected to stress waves. Abstract To investigate the dynamic response at the terminus of oblique intersecting joints subjected to stress waves, a ...
Gang Hu, Xiang Chen, Honglu Fei, Shijie Bao, Jian Guo   +4 more
wiley   +1 more source

Failure analysis and structural design improvement of support device for heavy-duty rack and pinion hydraulic actuator. [PDF]

Sci Rep
Zhang D, Luan B, Chen F, Zhu X, Xie Y, Wan Y, Ji S, Wang C, Choi JH.   +8 more
europepmc   +1 more source

Carbon emission assessment of tunnel infrastructures: From construction to operation

Deep Underground Science and Engineering, EarlyView.
This study develops a lifecycle carbon accounting framework for tunnel infrastructures, covering design, construction, operation, maintenance, and dismantling. Applied to a subsea tunnel case, the framework reveals the carbon emission distribution among four typical tunnel types and highlights potential carbon offset methods for low‐carbon tunnel ...
Luyuan Long, Wout Broere, Xuehui Zhang, Tian Xia, Richard de Nijs   +4 more
wiley   +1 more source

Thermo-hydraulic performance optimization of different louvered strip inserts inside a heated tube employing Al₂O₃ and CuO water-based nanofluids. [PDF]

Sci Rep
Almohammadi BA, Refaey HA, Alsharif AMA, Elsayed K, M Abdulhasieb H, Karali MA.   +5 more
europepmc   +1 more source

Investigation on tunnel stability considering pipe‐roof support with transparent soil technology

Deep Underground Science and Engineering, EarlyView.
This study integrates transparent soil technology, 3D reconstruction and numerical simulation to captures the full‐field deformation of shield tunnel instability. Results demonstrate that pipe‐roof support enhances stability via the “soil‐arching barrier effect,” effectively restraining failure wedge development by extending stress transfer paths ...
Zhi Jia, Yunpeng Ji, Zhao Lu, Honghua Zhao, Limin Zhang   +4 more
wiley   +1 more source