Results 161 to 170 of about 740,378 (196)

Rubber supported hydrostatic thrust bearings with rigid bearing surfaces

Tribology International, 1997
Abstract The film pressure of tilted hydrostatic thrust bearings results in a tilt opposing moment. This self-aligning action of the tilt opposing moment can be used effectively to reduce the deflection of the film contour. For this reduction some adjustment (elasticity) of the bearing system is necessary.
A. van Beek, A. Segal
openaire   +1 more source

Centrifugal Effects in Misaligned Hydrostatic Thrust Bearings

Journal of Lubrication Technology, 1983
An analysis is conducted and solutions are provided for the effect of centrifugal forces on hydrostatic misaligned thrust bearings. The results show that centrifugal forces reduce considerably the load capacity, the friction torque and increase the lubricant flow rate.
openaire   +1 more source

A non-central feeding hydrostatic thrust bearing

Journal of Fluid Mechanics, 1975
In a conventional hydrostatic thrust bearing, the lubricant is supplied from the centre and flows radially outwards. It has been found that the load capacity of such a bearing decreases with increasing angular speed of the rotor. The bearing fails when a critical rotor speed is reached at which the load capacity becomes zero.
openaire   +1 more source

Static Load Performance of a Water-Lubricated Hydrostatic Thrust Bearing

Journal of Engineering for Gas Turbines and Power, 2017
In rotating equipment, thrust bearings aid to balance axial loads and control shaft position. In turbomachinery, axial loads depend on shaft speed and pressure rise/drop on the impellers. This paper details a water-lubricated test rig for measurement of the performance of hydrostatic thrust bearings (HTBs).
Luis San Andrés, Michael Rohmer, Scott Wilkinson   +2 more
openaire   +1 more source

A note on hydrostatic thrust bearings with offset load

Wear, 1973
Abstract The note outlines a general method of solution for a hydrostatic (externally pressurized) multi-recess thrust bearing with offset load using an incompressible lubricant.
openaire   +1 more source

Inertia Effects in MHD Hydrostatic Thrust Bearing

Journal of Lubrication Technology, 1969
An approximate analytical study is made of inertia effects in magnetohydrodynamic lubrication flow between two parallel disks, one of which rotates at a constant angular velocity in an axial magnetic field. Fairly good accuracy of the approximate solution is confirmed in the special limiting case of zero rotating speed.
openaire   +1 more source

Experimental research on a hydrodynamic thrust bearing with hydrostatic lift pockets: Influence of lubrication modes on bearing performance

Tribology International, 2022
Michał Wodtke, Jean BOUYER
exaly  

High-speed and heavy-load tribological properties of hydrostatic thrust bearing with double rectangular recess

International Journal of Hydrogen Energy, 2022
Xiaoodong Yu, Jianhua Jiao
exaly  

Design of hydrostatic thrust bearings

Wear, 1967
openaire   +1 more source

Effect of design parameters and operational conditions on the motion accuracy of hydrostatic thrust bearing

Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, 2020
Jun Zha, Penghai Zhang, Runlin Chen
exaly