Results 51 to 60 of about 15,258 (170)
Ignition study of high-energy materials containing Al, B, AlB2 and TiB2 powders
MATEC Web of Conferences, 2017 Boron and its compounds are considered as possible high efficiency fuel components for high-energy materials (HEMs), since they have high gravimetric and volumetric heats of oxidation in comparison with aluminium powder.
Korotkikh Alexander +3 more
doaj +1 more source
Research of influence factors on characteristic parameters of coal dust explosio
Gong-kuang zidonghua, 2014 Influence of particle size, concentration and ignition energy of coal dust on the maximum pressure and its rising rate of coal dust explosion were researched by use of 20 L spherical explosion equipment. The research results show that under the condition
LIU Zhentang, GUO Rulin, XI Runze
doaj +1 more source
Research on secondary explosion characteristic of coal dust
Gong-kuang zidonghua, 2018 Influence of concentration, particle size and ignition energy of coal dust on secondary explosion characteristic of coal dust were studied by use of 20 L spherical explosion device, and the secondary explosion characteristic of coal dust was compared ...
LIU Haoxiong +5 more
doaj +1 more source
A STUDY ON THE ENGINE PERFORMANCE OF A SPARK IGNITION ENGINE ACCORDING TO THE IGNITION ENERGY
Journal of Energy Engineering, 2014 The more or less homogeneous fuel-air mixture that exists at the end of the compression process is ignited by an electric ignition spark from a spark plug shortly before top dead center. The actual moment of ignition is an optimization parameter; it is adapted to the engine operation so that an optimum combustion process is obtained.
openaire +2 more sources
Polymer TestingPolymer materials are prevalently used in the fabrication of oxygen equipment valves; however, they pose significant risks of ignition and explosion, often triggered by electrostatic charges.
Wei Yan +6 more
doaj +1 more source
Method to Determine the Electrical Energy for Ignition of Electro-Explosive Devices
Journal of Aerospace Technology and Management, 2015 During field trials, it was observed that the delay of ignition of electro-explosive devices (EED) depends on ratings of power supplies or dynamo and also on the firing cable lengths.
Aleti Sudheer Babu +3 more
doaj
Analysis of Energy Transfer in the Ignition System for High-Speed Combustion Engines
EnergiesIn order to produce reliable and reproducible ignition of lean fuel–air mixtures and highly stratified mixtures, it is necessary to ensure a high concentration of spark discharge energy and to provide a strong energy impulse for the triggering of chain ...
Filip Szwajca +2 more
doaj +1 more source
Ignition on the National Ignition Facility: a path towards inertial fusion energy
Nuclear Fusion, 2009 The National Ignition Facility (NIF), the world's largest and most powerful laser system for inertial confinement fusion (ICF) and experiments studying high-energy-density (HED) science, is nearing completion at Lawrence Livermore National Laboratory (LLNL).
openaire +2 more sources
Ignition and flame propagation behaviors of titanium alloys in oxygen-enriched atmospheres
Journal of Materials Research and TechnologyTitanium and its alloys are promising structural materials for advanced aircraft engine applications. However, they are susceptible to ignition and combustion because of their active chemical performance, high combustion heat, and poor heat conductivity.
Congzhen Wang +5 more
doaj +1 more source
WAYS OF INCREASING AIR-FUEL MIXTURE IGNITION RELIABILITY OF GAS ENGINES FROM ELECTRIC DISCHARGE [PDF]
Avtomobilʹnyj Transport (Harʹkov), 2010 The results of the rated estimation of the air-fuel mixture ignition energy of gas engines has been shown. The research of influence of hydrogen additions in different proportion on fuel-air mixture ig-nition process in the gas engine has been carried ...
F. Abramchuk +3 more
doaj