Results 281 to 290 of about 608,944 (344)

Manufacturing Continuous Fiber‐Reinforced Printing Filaments: Development of a Post‐Consolidation Unit

open access: yesAdvanced Engineering Materials, EarlyView.
A novel, temperature‐controlled post‐consolidation unit is developed to test its potential to improve the melt impregnation process used to manufacture continuous fiber‐reinforced filaments for additive manufacturing of high‐performance thermoplastics.
Daniel Beermann   +2 more
wiley   +1 more source

Rheocasting versus Die Casting: An Insight into the Low‐Cycle Fatigue Behavior of AlSi7Mg0.6

open access: yesAdvanced Engineering Materials, EarlyView.
The study compares rheocast lightweight components with high‐pressure die cast materials regarding microstructure and fatigue behavior. Rheocast process offers higher efficiency due to lower casting temperatures. Despite some microstructural differences, both processes show similar strengths (yield strength 125 MPa, tensile strength 240 MPa).
Julia Richter   +4 more
wiley   +1 more source

Video-rate tunable colour electronic paper with human resolution. [PDF]

open access: yesNature
Santosa ASS   +5 more
europepmc   +1 more source

Design and Prototyping of Topology‐Optimized, Additively Manufactured Lightweight Components for Space Robotic Systems: A Case Study

open access: yesAdvanced Engineering Materials, EarlyView.
The results demonstrate a simulation‐driven workflow that applies LSB topology optimization with additive manufacturing constraints to mission‐specific load cases, integrating European Cooperation for Space Standardization compliant verification and manufacturability to develop structurally efficient rover suspension components.
Stelios K. Georgantzinos   +11 more
wiley   +1 more source

Proof-of-Concept Study: Hyperspectral Imaging for Quantification of DKK-3 Expression in Oropharyngeal Carcinoma. [PDF]

open access: yesBioengineering (Basel)
Mittermair T   +5 more
europepmc   +1 more source

Home - About - Disclaimer - Privacy