Results 21 to 30 of about 543,974 (301)

Identifying rate limitation and a guide to design of fast‐charging Li‐ion battery

open access: yesInfoMat, 2020
Fast‐charging is highly demanded for applications requiring short charging time. However, fast‐charging triggers serious problems, leading to decline in charge acceptance and energy efficiency, accelerated capacity degradation, and safety risk.
Sheng S. Zhang
doaj   +1 more source

Analysis of Li-Ion Battery Cell Internal Impedance Changes Based on Temperature and Soh

open access: yesActa Electrotechnica et Informatica, 2022
The paper is focused on the analysis of changes in the internal impedance of the selected battery cell. In addition, the paper describes basic information about these batteries, their advantages/disadvantages and possible uses.
Biľanský Juraj   +3 more
doaj   +1 more source

Acoustic Vector-Corrected Impedance Meter [PDF]

open access: yes, 2014
We describe the development of a novel instrument intended for the measurement of the acoustical reflection coefficient of materials. The instrument effectively implements a one-port vector-corrected network analyzer in the acoustic, rather than the ...
Scott, Jonathan B., Pennington, Kyle
core   +1 more source

Enhanced magnetic flux density mapping using coherent steady state equilibrium signal in MREIT

open access: yesAIP Advances, 2016
Measuring the z-component of magnetic flux density B = (Bx, By, Bz) induced by transversally injected current, magnetic resonance electrical impedance tomography (MREIT) aims to visualize electrical property (current density and/or conductivity ...
Woo Chul Jeong   +5 more
doaj   +1 more source

Recycling of Li−Ni−Mn−Co Hydroxide from Spent Batteries to Produce High‐Performance Supercapacitors with Exceptional Stability

open access: yesChemElectroChem, 2020
The intensive implementation of Li‐ion batteries in many markets makes it increasingly urgent to address the recycling of strategic materials from spent batteries. Batteries typically contain toxic chemicals and cannot be disposed of at will.
Yasmine I. Mesbah   +3 more
doaj   +1 more source

Continuous Nondestructive Monitoring Method Using the Reconstructed Three-Dimensional Conductivity Images via GREIT for Tissue Engineering

open access: yesJournal of Applied Mathematics, 2014
A continuous Nondestructive monitoring method is required to apply proper feedback controls during tissue regeneration. Conductivity is one of valuable information to assess the physiological function and structural formation of regenerated tissues or ...
Sujin Ahn   +5 more
doaj   +1 more source

Dynamic Primitives in the Control of Locomotion

open access: yesFrontiers in Computational Neuroscience, 2013
Humans achieve locomotor dexterity that far exceeds the capability of modern robots, yet this is achieved despite slower actuators, imprecise sensors and vastly slower communication. We propose that this spectacular performance arises from encoding motor
Neville eHogan, Dagmar eSternad
doaj   +1 more source

Determination of the dynamic characteristics of a gear pump by the load variation method using special bench systems

open access: yesAdvanced Engineering Research, 2022
Introduction. Some of the major factors in the occurrence of vibration of units, causing fatigue failure of the housings of elements, pipelines, and failure of pump elements, are pulsations of the working medium in the hydraulic systems of machine tools,
V. I. Sanchugov, P. D. Rekadze
doaj   +1 more source

Wake and impedance [PDF]

open access: yesAIP Conference Proceedings, 2001
Lecture presented at JAS'2000 Accelerator School On Frontiers Of Accelerator Technology: High Quality Beams, St.
openaire   +2 more sources

Scanning Impedance Microscopy: From Impedance Spectra to Impedance Images [PDF]

open access: yesMicroscopy Today, 2001
Abstract The properties and performance of electronic devices are crucially dependent on interface-related phenomena. The presence of interfaces can enable electronic device functionality (p-n diodes, solar cells); alternatively, non-functional interfaces can degrade device performance (ohmic vs. non-ohmic contacts).
Sergei V. Kalinin, Dawn A. Bonnell
openaire   +2 more sources

Home - About - Disclaimer - Privacy